Re: 10" tailstock on a 12" Craftsman lathe?
|
As I think that I mentioned earlier at least indirectly, the same 10D-603 tailstock was used on the 10¡± and 12¡± lever operated tailstocks and tailstock turrets.? So actually four accessories, albeit I¡¯m sure that all were limited production. ? ?
toggle quoted message
Show quoted text
From: [email protected] [mailto:[email protected]] On Behalf Of Bill Williams
Sent: Monday, January 14, 2019 08:57
To: [email protected]
Subject: Re: [atlas-craftsman IO] 10" tailstock on a 12" Craftsman lathe?? ??? ??? Wow, a separate casting for a limited production accessory! Those were "The Good Old Days!" I have tinkered with the design of a capstan feed tailstock but with the capability of having a driven spindle for deep hole drilling. So far just an adapted wood lathe tailstock and parts from an old boat steering rack and pinion.??? ??? ??? Bill in Boulder CO USA ? On 1/14/19 12:29 AM, cwlathes wrote: Hi Bill . . .? Factory
Here is an extract from the catalogue from the ¡°Good Old Days¡±
Regards, ? Carvel ? ? ??? ??? Carvel, is this a factory one, an aftermarket accessory, or a shopbuilt one?? Bill in Boulder CO USA ? ? On 1/13/19 1:36 PM, cwlathes wrote: Just to follow on Robert¡¯s description , for those of you who may not have seen one given its comparative rarity , here¡¯s a pic of a lever action tailstock . . .?
Comes in handy occasionally . . . like when you have to drill out 200 crimping sleeves ?:>( :>(
Keep well, ? Carvel
|
