Re: Finally workbench for my lathe
|
What size is is the motor shaft? A DC motor could work, and if it doesn't, I could put it on my bandsaw.
toggle quoted message
Show quoted text
I'm easy. Not cheap, but easy. :) Bill in OKC -------------------------------------------- On Sun, 1/6/19, Ralph Hulslander <rhulslander@...> wrote:
Subject: Re: [atlas-craftsman IO] Finally workbench for my lathe To: [email protected] Date: Sunday, January 6, 2019, 10:54 AM Since we are talking about my new workbench/tool cabinet I am ready toadd a Consew 3/4hp Brushless Dc motor to my Craftsman 12x36 lathe. I have one on my 14" Delta Bandsaw and it works great! and for $132.49 much cheaper than going 3ph! Ralph On Sun, Jan 6, 2019 at 10:47 AM Bill in OKC too via Groups.Io <wmrmeyers@...> wrote: It wasn't the Atlas I was talking about there, but its new companion, a South Bend Heavy 10L toolroom lathe. Also known as a gunsmith's lathe. I can see it needing a heavier motor. Uses 5C collets rather than the 3C's Atlas uses. 1-3/8" spindle through hole. SNIP! _._,_._,_ |
Bill in OKC too