开云体育

Varney itself also used the straight sided cylinders at some point. An old ad shows then on a 10 wheeler also (with valve gear).

I have ever been able to get HOSeeker to open using several computers. The Varney Old Lady cylinders slanted inward at the top. The Bowser version used cylinders that were basically straight

I can't verify a ''change'' to the steam chest / cylinders ? Go to hoseeker.org literature section to look at the diagrams ??? Hope this helps . Henry

Hey Mr. Jeff ! I don't know if the other post got there BUT , the tank dimensions are 3/8'' by 1'' very close [ 6mm.by 24mm.and 18mm. between the hold down straps . Make the ends ''Plain Jane '' , not

I have an Old Lady by Varney. I know Bowser reworked these kits and changed the cylinders and frames. Does anyone know if the newer style Bowser cylinders will fit the old style Varney

Yeah. If you don't mind. That'd be helpful. Did you acquire this as a kit or did you pick up the detail parts separately? Do you happen to have a parts list? Jeff jppellas@...

I looked at the No.East Rails PRR steam roster pix , that fat tank is doable with your own stuff and skills . Air lines both sides , ''skinny'' hold down bands ? All possible !! Henry

Do you want me to measure the tank ?? Henry ?

I have the boiler, frame extension, decapod chassis and tender but no air tank or other detail parts. I am sure I will never lay my hands on that original Cary air tank but should be able to scrounge

I got one of these a while back , detailed nicely . One area gave me fits tho' , the pilot and big air tank . The clearance to the foot boards was way to skimpy . So I played with it for ever until I

Thanks Jeff !! I can relate , I have CRS as well !! Can;t remember Stuff ????? Henry

Henry, I'm sorry but I must have parted with that second JE Yardbird. Can't find it! However I did check with Bowser and they still have A5 parts including a side rod set for

Here's hoping it all goes through without a hitch! Regards, Walter yardbirdtrains@...> wrote:

Thanks Jeff , I might get one goin' yet . [????] Thanks again . Henry

Henry, I had a spare Yardbird at one point. I'll go down into the vault and see if I can dig up the rods you need. By the way, I recently acquired a Bowser A5. At first I thought it was a

There weren't many footboard pilots on Pacifics ?? NYC had its variants , look out for variants of H5s ! Many . Henry

Jeff you're a wizard ! Nice work . I'm buried under Model Power FAs , Sharks , E units , Atlas FP7s ! . I'm going to do PRR variants , 5 or one stripe , with of without radio poles ??? Henry

I've a need for Yardbird side rods , main rods , itty bitty screws to hold 'em on ??????? Thanks . Angle mount bells for B&O C&O NKP ??? Henry !!

Excellent !!!!! Henry

Doug , you are a wizard !! NYC's K11 close to NKP's K class Pacifics ????? I can relate to your change of directions ?? I'm swimming in Sharks , FAs , E and FP7s ???? Henry Nice work Doug as always ,