Re: Best ways to control the volume of the QY-100.
|
Is this question deceptively difficult?
Sounds like you could put a volume pedal between the output of the QY-100 and the "aux-in" jack of the GP-10.??
This kind of continuously-variable attenuation of a line-level signal is what volume pedals were designed for, right?
Hey group.
I use a MIDI pickup equipped guitar+ Roland GP-10 guitar processor.
To make a story short, the Roland module will output MIDI to the QY-100.
Then the? audio output of the QY-100 gets conveniently re-sent to an "aux-in" input in the back of the GP-10.
So this ends-up? combining the guitar tones of the GP-10 with the synth module output of the QY-100.
My dilemma: I need the QY-100 audio volume level to be pedal controlled, (a volume pedal).
What's the best way for me to get the audio output of the QY-100 to be volume-pedal controlled?
FWIW, the output is likely going to end up amplified in mono, not stereo as I use a single powered PA speaker.
Thanks for any suggestions.
Toomanyplugs.
|
Peter Block