On Tue, 10 Dec 2013, Eb Mayat wrote:
Hello Martin
Many thanks for the LFO parameter tables.
With regards to the DX11, on page 9 of the manual, the LFO --> Speed section
states:
"At a setting of 35, the LFO will make 6.7 cycles per second and at 99, 55
cycles per second."
So looking at your table, the Hz value for the LFO setting of 35 concurs
with that in the manual. There is, however, a slight discrepancy for the Hz
values corresponding to the LFO setting of 99. Did you calculate the values
according to some equation ? . . . or was this table obtained from a certain
source ?
If I look at the table 97, 98, 99 all have 52.91Hz. If I remember correctly this table was created using handmade measurements, guesses, and calculations. The highest values were probably missing or difficult to measure. if 97=52.91Hz, a value 99=55 Hz could be well right. 53 vs 55 Hz is not really bad IMO.
But maybe I can smoothen the table a bit more. Suggestions for improvements are always welcome.
I have attached PDF and Excel version of the table (same values as the previously posted txt version) to this message.
--
MT
