开云体育

Does anyone have one of those rigs? I cant get it to works on 60m and 27Mhz. Have tried the options found searching and nothing. It was purchased in Japan.

I have tried 111010, nothing. I have a japanese model, I'd like to use 11m band. Gives me error. Any help?

That does not make sense, unless the UHF is banded 410 to 439 and 440 to 470 Sent: 23 July 2022 14:55 To: Andrew Lenton Cc: [email protected] Subject: Re: [YaesuFT847] If low at O/P then trace

GO on pin 3 or the collector of Q2014, there should be a healthy signal there on RX as it is working! And on TX the seam level but a different frequency 73 Andrew Sent: 24 July 2022

Dear Max, Take a look below: The UHF path to the LO output is slightly different to VHF so from D2018 it is the same, Q2022 is unique for UHF Bottom line: there is switched power on

I do not believe in two faults, the VCO assuming it is a VCO, might me fixed frequency and the if moves to change frequency. Check 8 V on both VCO, tx rx, the check the o/p, tx and rx share a path,

Am I making the correct measurements?

Seems odd the voltages are good on the VF0 control voltage pin! There is not much to go wrong on a VCO I will see if I can find one! Get Outlook for Android

I'll button it up for now so I can get back to using it and look for a PLL board to replace. Would probably be the easiest remedy.

Sorry did not spot the attachments check directly on the the UHF TX VCO Does UHF RX work, judging by your measurements, I would say no. VHF frequency of 190 Mhz was unsepected, so the LO is high Looks

No content Get Outlook for Android

On Sat, Jul 23, 2022 at 6:03 AM Andrew Lenton <a@...> wrote: Hi the SAT button on and off a few times! > * Hitting the SAT button lights up all the buttons for sat operation. Do hear

Hi the SAT button on and off a few times! Check Q2017 is switching as this will kill off the UHF RX and TX LO this should be working as RX is working can you confirm this, tx on a hand held or

Indeed we are, I will track the fault down over the weekend by studying the circuits 73 Andrew Get Outlook for Android

Here are a couple of pictures for you all.

For those who were following this thread... I received my Tiny SA signal analyzer yesterday and started checking signals. https://www.tinysa.org/wiki/ The TX local oscillator signal is present on

Hi Max, OK you need to check J3006 TX I.F., and J3007 TX LO, they are common to VHF and UHF, The LO is the bit that changes frequency, check it does and the level is the same on VHF and UHF, if

J3008 - TX IF ~ 600mV Checked D3035 and D3036? both 0.762V one way, nothing the other

Voltage readings: J3015 pin 7 (UT8)? 7.83V J3016 pin 3 (UT8)?? 7.83V J3011 pin 1 (UHF T8)?? 7.83V

Hi Everyone, I received the below in my email today.? I hope somene can help the gentilman. :)? I'll give the group first dibs on this, then it'll be going up for grabs on QRZ.com.? Do NOT