Re: FT980 dose not recieve
|
?I am wondering if you have an HMI.
I DONT HAVE IT
Q: Can you receive or hear anything on AM or FM modes??
ANY AT ANY BAND AND MODE.
Q: When was the last time you replaced the RAM backup batteries (behind the panel under the rig)? Have you done a RAM reset (pull out the batteries for at 2 minutes, replace with fresh batteries)? A lot of issues can be traced to this ... I THINK IS IS OK, IT KEEPS THE FREQ AND MODE FROM DE LAS TIME IT WAS TURNED ON.
?Have you done a RAM reset (pull out the batteries for at 2 minutes, replace with fresh batteries)?
I WILL DO IT
THANKS
On Thursday, September 23, 2021, 01:15:20 PM GMT-4, Mat Breton N8TW <i.m.n8tw@...> wrote:
The BFO VCV is a very common issue, but not the only potential one. It will drift over time, and eventually reach a point where the VCV doesn't work at all and you get nothing on CW/SSB.? Switching LSB-USB without any change in the VCV frequency is interesting. I am wondering if you have an HMI.
Q: Can you receive or hear anything on AM or FM modes? If yes, the BFO is likely at least operational and we should look elsewhere.
Q: When was the last time you replaced the RAM backup batteries (behind the panel under the rig)? Have you done a RAM reset (pull out the batteries for at 2 minutes, replace with fresh batteries)? A lot of issues can be traced to this ...
--
-Mat Breton, N8TW
|
