开云体育

In the hopes it will help someone else, resolving “Failed to communicate with radio: Radio is not responding” on my Mac running El Capitan came down to finding out that I had installed FTDI

If you really must use this mic, you will need to make an adapter cable. The FT-60R uses a 3.5MM TRRS connector. you can get these from e-bay, just search "3.5MM TRRS" Be aware that the difference in

Jon, Contact Les Poston at?http://hammadeparts.jivetones.com/?I'm sure he may be able to help you. 73, LarryGKC0FD

I don't have that much expertise on the matter. Good luck, hope you find your answer.SEP

Hi, I would like to use my favorite mic, a Cobra 4 pin with the FT60r. Is it possible to make an adaptor for this or are the 2 incompatible? Attached are wiring diagrams for both. I think the Cobra is

It works. De. AF0DJ

You are 59 , oh wrong group. You are full quieting. -- KQ?J

Just a quick test to the FT-60 reflector after having to set up a new Yahoo ID and thus rejoin all my amateur radio groups. 73, Nolan Kienitz KI5IO Nolan@... Plano, TX

Have you done a reset? Jardy Dawson WA7JRD Nobody really cares what device you are using, as long as YOU like it!

thanks wassim for the reply. i guess the unit needs servicing. tried it out on different frequencies, all the same. on one frequency, rx is S4 on both full squelch and engaging rf squelch, while on my

Hello Gcmateo How weak is the signal that you are trying to receive? Can you test your radio with a friend in an open field say far away from you that you can see him/her but not hear him/her at all

good day everyone! anybody has/having this problem? my FT60 has been having difficulty receiving unless i turn counter-clockwise fully the squelch knob and thus bringing up the noise. but receives ok

Correct. The audio frequency response of a repeater receiver typically will not pass a CTCSS tone through to the transmitter. That's why the repeaters that DO transmit tone have a dedicated encoder

I have set the all repeaters that I manage to transmit 88.5 Hz, which gives users the option to use full CTCSS if they want to. My ft60 has full CTCSS on the VHF repeater channel in memory. France has

Personally, I do not have ANY of my local repeaters set to TONE SQ - where the unit TX a tine and is set to only break squelch if it hears an incoming tone. Two main reasons: 1. Most of the repeaters

I think the first thing I would look at is do I have the decode turned on. If you have repeater channels in memory and have the correct codes set up and are hearing them when stopped on that frequency

This would have to be done on each channel, as it is not a universal setting. (F) 1 works, also. Jardy Dawson WA7JRD Nobody really cares what device you are using, as long as YOU like it!

Is your manual squelch set to high? Jim Bassett, W1RO-ARRL Nevada Section Traffic Manager, Life Member AFA9RO gobig.Isagenix.com

It sounds like you may have "SQL.TYP" set to TSQL for all memory channels and the VFO instead of using TONE as your default setting. When you see activity on a frequency but you are unable to hear

The use of tones (CTCSS) has nothing to do with the offset. If you are using tones, keep tsql off. Jardy Dawson WA7JRD Ham Radio Message relayed through SETI (Search for Extra-Terrestrial