开云体育

I bought two Yaesu trays and enough Enloop AA batteries to fill them. They appear to hold their charge very well in storage; however, I can't get the clip to close. It appears the Enloops are slightly

I think a good solution is to purchase one or two of the AA-cell battery trays for the radio (I just have one tray, but have been thinking of getting one more), each of which holds six batteries. Then

Got mine from Amazon $13.59 with free shipping. http://www.amazon.com/FNB-83-Replacement-Battery-1400mAh-VX-210A/product-reviews/B00VB9HDD6 Since this is a new purchase I have no info

Hey Fred and All, As you said "OH dont throw away the old battery" when you have the time, you can disassemble them, and make an AA battery tray out of them. 73 Wassim WN6WJN >

Where did you purchase the battery and how much please. I need to get a few also. mine been doing same tyhing for a long time. got a ft1dr so not using the ft-60 as much. I have seen cheap batteries

Installing a new FNB-83 battery has solved the problem. Transmitting is working fine now. Appreciate all the suggestions. Hank KB1JLA Sent: Friday, July 15, 2016 9:28 PM To:

Hello All "We are assuming that you are loading a freq within the ham bands, right?" But even if the frequency is out of band, or the capabilities of the radio,the normal behavior is 1) not to allow

Thanks.

It works fine on the car cig lighter plug, so pretty much confirms bad battery. Have a new one on order. Appreciate the feed back. Hank KB1JLA I did check the offsets, etc. and those were ok.

If you are trying to transmit outside the ham bands, the radio will beep and show 'error'. Turning off and on is a bad battery, even if voltage shows high enough on power on. If it works when on a

Hank, You might also check the offset. I did this, and the offset frequency was OUTSIDE the hamabands, even though the recieve frequency was inside the hambands. I checked the offset and it appears

It sounds like the battery voltage is pk under the light load condition of receiving. Batteries often start to fail by not being able to supply high current..

The ADMS-1J programming kit has been sold. 73, Jim K5JG

Yes! Thank you. The FT-60 transmits fine on the stock E-DC-5B car cig lighter charger cord. Voltage reads 12.4 volts on the FT-60. I have two stock FNB-83 battery packs that are fully

Correct. Programing local ham repeaters. Sent: Tuesday, July 12, 2016 11:10 PM To: FT-60@... Subject: RE: [FT-60] FT-60 Possible Problem- suggestions? We are assuming that you

We are assuming that you are loading a freq within the ham bands, right?

I have the following FT-60R accessories for sale: 1 - RT Systems ADMS-1J Programming Software (with installation key) & USB Cable all in the original box. 1 - VAC-370B Drop-in Rapid Charger &

Sounds like a bad battery or you are trying to transmit while charging. Plugged into a cigarette lighter plug will work, the wall wart won't. Jardy Dawson WA7JRD Sent from the Death Star for Darth

Encountering a problem in programming my FT-60. After entering a frequency (frequency+tone+tone freq.) and storing it in memory channel #2 (for example) any attempt to transmit on that channel

Thanks for the replies and suggestions. I guess I'll have to go thru and try it again until it works. I thought I was but maybe I'm missing something. Thanks again Hoyt