开云体育

Hi Guys, Does anyone have a High Res Scan of the FT-101ZD Brochure at all, been trying to locate one but all I can find are Low Res versions. Kind Regards James MD0MDI www.md0mdi.im (

Depending on condition & accessories, $500 - $700

What price range are you looking for? [email protected]> wrote:

Dave W0ZY

This is exactly what my FT101Z is doing <see thread elsewhere on here> - only difference perhaps is that this happened suddenly with me.? Assistance from others on here has been much appreciated.? I

Ah... here we have a? sticking point - I do not have an oscilloscope and only a fairly basic home made RF probe for my digital meter.? Although I understand the various circuit diagrams and the

I found this And I’m looking through the manuals I have hear Dave VE3DPC

OK Keep in mind that for the most part, the marker generator is strong enough to be used as a built in RF generator. Great for tracing signals. Most rigs will see about an S9 +5dB to +15dB on the S

Thanks Bruce.? From? the main circuit diagram the antenna signal wends it's way from the SO239 to AGC switch <already checked this is OK> to an inert tuned circuit (L01/C07)<'9mhz trap'> on the

Yes, that really sounds like a bad solder joint somewhere. Whether it is on the RF board ormot is another matter but since the marker is weak and so is the received antenna signals... I'd get the

The marker generator works but at a low level across all bands although maybe louder on some - it will not move the S meter but is clearly audible and fades out when RF gain is turned fully

Thanks gentlemen for the circuit information - as always appreciated

Too small Try this PDF one

The attachment is the 2154 board schematic

Very good. I also have a MKIII ZD with that newer RF board. I think I have the schematic for it somewhere. Does your marker generator work well enough to use as your signal generator.... for the most

Hi Alistair, I just uploaded the manual you need for PB2154. Please look in the Files section Folder 7 for FT-101ZD_MK3_serv.pdf. Look at Page 5-8 Adobe page 9. 73 Roger VE7LB

Thanks so far.? I have cleaned and verified that the Attenuation switch is clean and working as it should.? Further research inside the equipment and the internet I find that the RF board in my

other possibility replace 3sk51 by BF964N https://web.archive.org/web/20210722044739/http://retro.co.za/zs1ke/FT-107/index.html other 3sk40 by NTE 454 = 3sk70 73 Emerson Em qui., 21 de out. de

I’m learning thanks men; and I have that spray for guitar audio etc there are several types available now too. It’s contact spray that should not harm plastic. I can’t wait to start my check out

Thank you Emerson – your information much appreciated Al GM4ENF Sent: Wednesday, October 20, 2021 6:52 PM To: [email protected] Subject: Re: FW: [Yaesu-FT-101] Deaf FT101Z Hi about 3sk53