开云体育

I have an early FT-101 SN below 25000. Problem is it has no 13.5 volts. It keeps blowing D7 and shorting D8. I have replaced them with IN4004's which seems to be what most people use. I have also

My turn for questions to the greater group as to what to do first. I am pretty much at the last phase of my refurbishment of the FT-101B I have one issue to where the frequency on the rig and the

Any questions you may have, I will certainly reply. Best of luck....It has been fun. Slow and Steady has been my mantra. And lots of pictures.... ; - ) -- Butch - KA?WWT

No need to apologise - I have found your posts of use.? I expect to go down same kind of route with my 101Z at some point and your information has both encouraged me and given some degree of

Congrats!

I performed the rx and tx alignment by watching The Radio Shop video #142 on YouTube. I am now .5 KHz off, down from 2.5K off. !!!! Man, this is fun. Sorry if I am bugging anyone with my posts. But

Dave, Everything that I have posted in this thread is how I finally got to this point. I believe the biggest thing was that I had some bad cap components that were changed out. During my initial

Please explain what you did to get to this point?

Today was a big day for the radio and I. I can NOW adjust to 50 milliamps idle driver current. THIS IS HUGE for me! And the radio will tune up on 80 (hot) 40, 20, 15, and 10A. The power out seems

Tom, Nowhere do I see where he sets the idle driver current to 50 ma initially. My hope is that passes muster first, then I can go through with the other adjustments. The steps in the manual won’t

There was, but it was for a different freq range. 32.520 was in that slot. It needed to be 35.520 I edited my boo-boo above. -- Butch - KA?WWT

Sorry for the obvious question: Is there a crystal actually installed for 10d ?

E-PIFFIANY Installed currently in 10D: crystal is 32.5200 Installed currently in 11: crystal is 32.020 10D should be 35.5200 11 should be 33.020 33.020 and 32.520. Translates to 26.000 and 26.500

https://rogerkennedy.co.uk/g3yro/ft101alignment.htm Take a look at this link. The author is a highly respected 101 service guy for Yaesu in Great Britain and is a wealth of wisdom. I resuscitated my

I have everything back together and all is working....almost all working. Band 10D is deaf. It does not hear the internal 100 or 25KHz generated tone. I have not begun to perform an alignment as I am

I finished up all the parts replacements (caps, resistors) on my FT-101B today.Throughout the past week or so, I powered up the rig twice for a smoke test and both time it passed with no burn marks

This is gonna sound cryptic......but it also makes perfect sense too. TARN-X!!!!!!!!!!!! OH-FREAKN' MY!!!!!! Big Grin. -- Butch - KA?WWT

I really appreciate your feedback. Good luck with your 101, hope soon we can see some picture when is complete. 73 OA4BMG Claudio Bio groups.io <ka0wwt@...> escribió:

The electrolytic caps I bought from a dealer on eBay that specialized in the kits for the FT series radios. https://www.ebay.com/str/kk4hxj?_trksid=p4429486.m3561.l161211 The particular resistor you

Hello Butch You are in the process that I need to start. It’s not easy at all for those of us who do it for the first time. Here in Peru is not too easy to found parts for old stuff. I ordered