开云体育

The red LED’S came out in the last runs of the FR-101 digital display models. 73 Roger VE7LB Sent: Thursday, January 11, 2024 1:42 PM To: [email protected] Subject: [Yaesu-FT-101] FR-101D

If you go onto the Fox Tango International website i think there are or maybe some info on there .There is alawys somebody on that site who will point you in the right direction . I also have the

I recently bought this FR-101D with LED display. It was very dirty inside and outside but with all filters, FM unit and a 2 meter converter. Last weeks I cleaned it thoroughly and everything seems to

Garden variety? Peter G0 LQU Eric W7EV wrote:

I'm assuming this radio has a garden variety changeover relay but wanted to check with those more experienced with the ZD.? Assuming the relay is the stock relay, are there any tricks I should be

Thanks again Peter. I'll look into those items. (when I next get the inclination!) Peter G0LQU Peter Roberts G4DJB wrote:

Okay Peter - that one sounds very much like a leaky C13. That capacitor couples the anode of the driver to the grids of the PA and is another of those known weak spots! I sounds as if your radio does

Hi Peter and many thanks for the additional advice. Actually I have decided to have a break from that radio - if anything there are other things not working - when I try to adjust the standing current

Hi Dan, Very good on the test bench set up. The dim bulb test should work fine. I don't have much in the way of test equipment ... a B&K isolation transformer, a digital 200MHz disk channel scope

Hi Ron, Yes, I have a variac.? My plan is to use a Tripp-lite isolation transformer I modified to be truly isolated.? Plug the variac into it and from the variac connect to the dim bulb tester with

Hi Dan, Do you have a variac? That would work. I used a multitap (90v-120v in 5v increments) isolation transformer when I brought mine back to life. Then it managed to blow both Q1 and Q2 on the

Hi Ron, Glad to hear the conversion worked out for you.? I had read some articles about the conversion but wasn't sure where that would lead me if I needed to do it.? I'm assuming these tubes are

Hi Dan, I was a little concerned about that as well. I actually triple checked everything I did before applying power. I used the cold neutralization process from the conversion article and added the

Hi Ron, I have the FT-101E that has been in its original box throughout the years since high school.? It had the 6JS6C tubes replaced once.? Not sure how long tubes last sitting around.??Prices

Hi Peter, Okay, so no SSB out even though you have AM & Tune/CW. It still could be a fault with the ALC or dirty relay. You could certainly check the voltages around D2 in the ALC circuit. If C17 has

Hi Peter and many thanks for your comprehensive reply! I will certainly try your suggestions for the metering fault. However I can get no power out at all using a dummy load (on a separate power/swr

Hi Peter, The D2 referred to is the D2 in the ALC circuitry which is located on tag strips in the chassis just outside the PA/Driver compartment - I think this is what you referred to as the D2 in

Hello. my first post for a long while so hoping somerone can help me. I have powered up this rig after many years in (dry!) storage. I was vey encouraged when in the "Tune" mode I obtained 120W out

Hey that worked perfect! Thanks for the tip! I figured there had to be a simple solution out there but couldn't find anything in the manual or online! Guess it was so simple that I should have just

Hi Michael, Not to worry, the metal ring on the vfo knob behind the plastic portion rotates with the analog dial. Hold the metal ring firmly and turn the plastic knob so the analog is correct. It