开云体育

Thanks Roger, just grabbed it! I have a 46 inch flat panel monitor, which makes it very easy for me to zoom in and out and navigate the large jpeg image, which I do indeed prefer to the pdf version

Sure Peter..her you go: https://www.facebook.com/groups/759974814527577/files/files With that group and the great folks on this reflector, I feel very confident that I will have my 101EX hearing

I'd be interested in the same... ; )Mike

Hi Richard, I suppose that you don't have a good pdf reader as the FT-101E_Late_Schematic.pdf in the files section is high res 11 x 30 inches. I just added a jpeg version of the same file in the same

Richard - do you have a link to those facebook files please? I'll actually have to join facebook now after resisting for many years! Kind regards Peter G0LQU Richard kn7sfz wrote:

I was able to download what I needed from the Facebook files...thanks all! Richard kn7sfz

Question from a newbie to the group. Has anyone scanned the long fold-out schematic for the FT-101E to a single high res jpeg file? If so, I would appreciate a link to download same. Being able to

All, Hi Joe here. Thanks in advance and your help in my quest to get an FT101E back to health. A friend of mine, an elderly ham, was transmitting without an antenna connected to the radio. Yes,

, .1aMike

Sorry Bruce, I just reread your initial post and see that it is the main analog dial that you are talking about. 73 Don ve3ids wrote:

With a digital display?

Mike, it is on upper side band. Bruce

Don, it is a FT-101E. Bruce

Is the radio on AM or SSB? Just thinking that might make a difference. Maybe not 12kc's but...Mike

Bruce, is this a FT 101zd? IIRC, I had to net the reference crystal in the counter module in my zd. I think it is accessible through a little hole in the top of the counter case after you lift the

Thanks Geoffrey but that page speaks to the skirt vernier dial.? My problem lies with the main frequency dial just above. Bruce

Mike, the main dial shows I'm at 14.048 when I inject a 14.060 Hz signal from my Elecraft XG2 receiver test oscillator. Bruce

Page 9 in the manual FT-101E, EE, EX Instruction Manual.pdf (iw2nmx.it) <http://www.iw2nmx.it/Yaesu/FT-101/FT-101E,%20EE,%20EX%20Instruction%20Manual.pdf> CheersVK5JB Sent: Saturday, 28

How many kc's is it off?Mike

Please advise how to align the main frequency dial with the actual frequency being used.? I'm referring to the top lighted dial.? I recall seeing somewhere that there is an adjustment (pot?) which