开云体育

Thank you! Sounds like a solid plan. I will let you know how it goes.

Thank you but I already have those manuals. As far as I can tell the schematics are all for B models and newer. Am I missing something?

Thank you! I'm well aware of Fox Tango.

de PP6EW Emerson FT-101_Early(1).pdf <https://drive.google.com/file/d/1weo-9Ao8VeJQ_JpDXclpX24A4LgcFnWj/view?usp=drive_web> Em sex., 21 de fev. de 2025 às 17:08, STEPHEN WIDDETT via

One or more of the lamps (meter, VFO, triangle) might be shorted.? That will blow the two diodes. Nestor VE7RSN

Fox Tango International. foxtango.org

No expert here, but can suggest a few things. Remove all the boards. Measure the resistance to ground of the 13.5 vdc line. If grounded, suspect the Dial Lamps housing shorting. If all ok then,

Is anyone aware of where I can find schematics for early (below 25000 sn) FT-101's? I have a copy of the Yaesu service manual but as far as I can tell all the schematics are for B models and up.

I have an early FT-101 SN below 25000. Problem is it has no 13.5 volts. It keeps blowing D7 and shorting D8. I have replaced them with IN4004's which seems to be what most people use. I have also

My turn for questions to the greater group as to what to do first. I am pretty much at the last phase of my refurbishment of the FT-101B I have one issue to where the frequency on the rig and the

Any questions you may have, I will certainly reply. Best of luck....It has been fun. Slow and Steady has been my mantra. And lots of pictures.... ; - ) -- Butch - KA?WWT

No need to apologise - I have found your posts of use.? I expect to go down same kind of route with my 101Z at some point and your information has both encouraged me and given some degree of

Congrats!

I performed the rx and tx alignment by watching The Radio Shop video #142 on YouTube. I am now .5 KHz off, down from 2.5K off. !!!! Man, this is fun. Sorry if I am bugging anyone with my posts. But

Dave, Everything that I have posted in this thread is how I finally got to this point. I believe the biggest thing was that I had some bad cap components that were changed out. During my initial

Please explain what you did to get to this point?

Today was a big day for the radio and I. I can NOW adjust to 50 milliamps idle driver current. THIS IS HUGE for me! And the radio will tune up on 80 (hot) 40, 20, 15, and 10A. The power out seems

Tom, Nowhere do I see where he sets the idle driver current to 50 ma initially. My hope is that passes muster first, then I can go through with the other adjustments. The steps in the manual won’t

There was, but it was for a different freq range. 32.520 was in that slot. It needed to be 35.520 I edited my boo-boo above. -- Butch - KA?WWT

Sorry for the obvious question: Is there a crystal actually installed for 10d ?