开云体育

Paul Harrold does top notch work and focuses on only the FT-101 series: Paul Harrold | Facebook <https://www.facebook.com/groups/759974814527577/user/100044138206352> Good luck, Richard kn7sfz

My title kinda says it all: Are there any shops that still work on/specialize in Yaesu FT-101E repair/restoration? I purchased a Yaesu FT-101E with a FL-2100 yesterday for $200.? The radio appears

When connecting an RF probe to the driver RF out RCA jack in the rear of the FT-101E, does anyone know what voltage should be present? I was wondering what signal level the finals are expecting to

Hello all, I have an ft-101e that I have recapped all the electrolytics and it now receives ok.? The finals are rca 6js6c's.? The tubes have been checked and are good but I want to know about the

Yaesu FT-101 HF Transceiver Web Page presented by Fox Tango International foxtango.org

I don't use social media. :-(

Definitely join the FT-101 group on Facebook...they have been of great value in helping me with my 101EX. https://www.facebook.com/groups/759974814527577 Richard kn7sfz

Hi, I bought an FT-101E "for parts or repair" on ebay. It's not here yet, but I need to start collecting data, manuals, etc. I bought an FGR-7 a few years ago which I completely realigned and

Perhaps I can beat your 42 years now Gordon!. I've just had another dry joint on my early FT-101 (FT-277) fail after almost 52 years. I had been working on the radio on the bench and was just doing

Update - I’ve replaced the 20m crystal and it’s now working well! I have a question though. I’ve been aligning the clarifier and the tx/rx with the Zero adjust. I noticed all the guides online

To all The moderator Roger has found a better quality copy of the article for the dmm connected rf voltmeter and has posted it in the files section, i have therefore removed the un needed photos of

Nigel jones 2E0NJT <nigel-jones@...> added the album Rf tester for dmm ( /g/Yaesu-FT-101/album?id=285945 )

Richard check out the photos section for “ rf tester for dmm” i have uploaded an adaptor you could build to give you the test results you need. nigel

Nigel jones 2E0NJT <nigel-jones@...> added folder */Rf adaptor for dmm*

Yes, by all means and there are plenty of YouTube videos on how to do that.? You can also use the probe with an analog voltmeter if that's all you have.? The manual wants you to shoot for 300mv

Richard thanks. No I don’t have any test equipment other than other radios receivers, DMM (not much use here) etc. I used a nanovna as a signal generator for the other bands alignment and that went

Hi Carl, As you've already discovered, the caps have just the two connections.? The right side is the rotor connected to ground. The small lead on the left connects the stator to the xtal.? Three

Ah yes noticed on the schematic, thanks. No 20 meters wasn’t working before. I tried adjusting TC18 during the alignment and first found it did nothing, then broke completely.

Carl, With the 3 leg trimmers, 2 legs are the same connection, the other is the variable connection. Was the 20m receiving before you tried adjusting T18? Regards, TF Sent:

Thanks Tony, this is what I suspected. I’ve ordered one off eBay so fingers crossed it’s a working one and it solves the problem. TC18 also shattered when I was attempting to tune the crystal