开云体育

This is great info, thanks!? I just tried to adjust it with the trimmer pot, and I could get it sorta close as long as the screw driver was on the pot, but as soon as I took it away, the marker tone

Never mind, I found it....

Looking on QTH but don't see it.

Thanks for the input, I can't find the elusive FH2 by tracing, using magnifying glasses, bright lights, mirrors, etc so I'm done with it. It's now listed for sale on QTH.com.

Your three local oscillator crystals, USB LSB CW.... could be off frequency too.

OK. Does your radio have the WWV receive crystal installed? If yes, tune the receiver to it and zero beat the carrier while listening with headphones. Then off tune a bit so you hear a 400hz to 800hz

Thanks Bruce. Something is off somewhere, I'm just not sure where. I know that if I pull up the 14.300MHz Maritime Mobile net, I can center the VFO dial on 14.300 and hear the net fine, so I feel

OK... How much do you want for it? [email protected]> wrote:

Plus, you have to adjust the 500KHz back dial of the VFO every time you switch from LSB, USB or CW... relative to zeroing your market generator.

Since the span between LSB and USB is about 2.8KHz, I suspect your 25KHz and ?100KHz points are just about right and the error factor is probably much less than 50-100Hz off. And the 601 is no way as

From the service manual - "The RF input signal from the antenna is fed through antenna relay RL2, lamp fuse FH2, attenuator switch S2004 (located on the lever switch unit...)" So trace the line from

Hi, I'm new to FT-101 world but am really enjoying it.? I recently got an FT-101E and have done a lot of work getting it to work properly.? I've recapped the entire thing, performed the clarifier

Thanks for the reply. That is where I've been looking, nothing that resembles a fuse or fuse holder in this tank cage that I see on the bottom.? There is a 3pos terminal strip mounted inside the back

If I recall correctly you take off the bottom cover and the bottom screen over the finals compartment. Trace the coax center line back from the PL259 jack an inch or two and you will see what looks

I bought this rig at a hamfest and the seller was less than honest, imagine that... Anyway, it loads up good but no receive, checking out what others suggest.? Specifically where is the Lamp that is

Is it feasible to add AM capability to a MK0? ?Does anyone have experience with this? Thank you. 73, Michael Smith, N4KZO

Dear Mick I'm not sure that I understood the complete problem, but if as you say " ALC/Power/IP still show the same readings if its putting power out or not ", I believe or think that is a relay

Hi all,? I Have a FT-101B that no longer produces output power. RX was and still is very good and stable It was producing solid power on all bands until a few weeks ago when it went to the bench for

Glad I am not the only one!

Well I've been doing this for 40m years... and I don't understand what you mean or what this conclusion is.... LOL