The wire wound resistors were OK. I cleaned the flying lead contacts and pins on tubes and tested the drive tube, which was OK. No tester was available for the PA tubes. Re-installed tubes and everything worked.
Completed the Rx and Tx alignment process and started 'on air' testing. Power out is low, (20 to 80 watts)? and Rx and TX frequencies do not match. (People have said 'You are off-frequency' every time I've made contacts on this radio.)? I have seen videos on fixing the latter issue and will try to locate matching tunes to get power level up.?
This thing is slowly rejoining the land of the living, but I have to say that using it makes me appreciate my TS590sg!
Tom ai4th