开云体育

I used some of these many years ago and they were awesome deals unfortunately they are discontinued https://www.pongrance.com/

Thanks but my budget is around $20

Mike M. See the link below which has my review of the Electronic Specialty

Hi Paolo, Thanks for the display info. I copied your pdf's over to the files section and added translated english versions as well:

Hi, please look at the attached articles (unfortunately they are written in Italian, but almost easy to be read). Good work, regards! Paolo Viappiani

has anyone added digital readout to their FRG-7 this year ?

I just took delivery of a fixer upper FRG-7. I did a full alignment but was still disappointment with the results of this receiver. So I put in on the bench and found that L101 (4 coils on a rod after

Great job Lex, I have two suggestions: I believe that spun replacements for the metallic inserts are available from restoration places but may have to be cut to fit. If you use ABS in black you can

Recently I got a question from a fellow ham if I have a replacement knob for the Fine-Tune. Unfortunatly I didn't but told them that I wanted to 3D design all the knobs of the FRG-7. So during my

I have noticed that the lock light in my FRG-7 dims with humidity. I doubt this is the problem that yitzimarks@... is observing, but I toss this observation in to see if anyone else has seen that

Hi, I hope it's not too off-topic to discuss the 8800 here as I can't find a dedicated group for this RX. Mine has problems with excessive contact bounce in the numeric keypad. What is the

Hi, just go through the area with a soldering iron and reflow all the connections. The main components that control the Led are Q110 and Q111, plus the surrounding resistors and capacitors. I assume

Thanks for the explanation. Last night I tested the voltage at the joint of the led wire. It was 1.45v when the led was working (fist time starting the radio after letting it sit for a few hours)

It gets worse because when the radio is on it heats up. The bad joint opens because of Thermal expantion. It might not be the wire for the Led, it could be any of the transistors, resistors, etc

But why would it get worse when the radio is on? I checked all the joints, they look fine.

Hi, sounds exactly like a bad solder joint. Probably at the pcb end. If your handy with a soldering iron, it should be an easy fix.? Hope this helps.? Bob On Wed, Aug 3, 2022 at 8:03 PM,

Hi there. My friend very kindly gave my his old FRG-7. It works really well and I love it! It has one problem. The lock Led will not work, unless the radio was turned off and sitting for a few

Levers arrived today, so quick ! thanks so much !

I can send a set of levers for Euro 2,65 (send as letter). Bigger parts (up to 350 gram) which fit in a letterbox package shipping will be Euro 11,50. -- 73 Lex PH2LB https://www.ph2lb.nl/

Yes, what is the cost including shipping to the USA for the red lever thanks