开云体育

Sorry my 3d printer friend decided to leave Calif.? So I haven't found another.? I do have a Grey switch lever though if you can use it let me know. 73 Bob

Do you have an update on a switch lever ? I need a red one

Yes, that's all it was... just needed a tickle of VR102 so the lock light was less fussy.? Thanks!

I'm curious about the design the 3D printer is using. I have designed spare parts for my FRG-7's and made the files are publicly available (for non-commercial

I have found a possible source for FRG7 switch handles.? This 3D printer made me a spinner knob and it works perfectly. Will let everyone know when? I get a quote. Bob

My lock light would not light up when I ran the FRG 7 on internal batteries. Member feedback suggested I had to adjust VR102 until the lock light would then come on for each band. Maybe that will

Hi all, My recently restored FRG-7 has developed a slightly annoying problem.? When cold, the 0, 1 & 2 MHz bands won't light up the 'lock' LED.? After some time warming up, the 0 & 2 MHz bands will

Hi, I'm looking to buy a GAR-7 digital display. Any leads on this would be appreciated. 73, Randy K7RAN

see if the board is routed through the ANL position of the mode switch

No Mike, there is not. A previous owner took out Q411 and some other components. There is more 'done' in de receiver. I will start to investigate and perhaps I rebuild with original parts or

Is there a front panel or any place where there is a switch to engage/disengage this mod board ? It does appear that the front panel mode switch is used. perhaps the ANL position switches in this

I have seen many filter upgrades in an FRG-7 but never one like that, also I do not see any ceramic or mechanical IF filter

Hi Kees, Is that an RCA CA3011 IC? The board looks like an aftermarket 455 KHz improved filter board. Maybe someone has seen it before. 73 Roger VE7LB

what is the part number on the IC on that board this mod looks like it was done in the 1980s

Hi all, I obtained a FRG-7 which is in working condition but needs still a lot of attention. An extra PCB is added and I really do not know which mod this is. I hope you can help me! There is also a

Thanks for the reply, Lex.? The knobs on my FRG-7 are all fine but that power switch is going to go.? I can wait until you can get the complete switch done. 73, Greg KD7SRC

Hi, I would appreciate a couple of switches if possible,,let me know the cost. Cheers Steve

Hello Greg, I don't have any complete switches yet (the FRG-7 for parts I got, didn't have the switchs anymore), but can send you a set of knobs when you want (still have your postal adres laying

Lex, Whenever you are ready to sell one of the red power switches let me know.? The one on my FRG-7 still works but is very loose. I sense that it is getting close to breaking. Greg Storms KD7SRC

I got my self a rol of red PLA (it's a little bit lighter then the red color of the original knob, but it will do) and printed me a few power switch knobs. The light switch knob is also a little