I believe I have the main dial set properly now.
Putting the scope on TP019 I get no waveform unless I move the MHZ dial down to the zero mark (where the led goes out) then I get the waveform below. It does not change when moving the second VFO.
?
But when I put the scope on TP401 I do get a waveform that changes in frequency from 3.35 mhz to 2.42 mhz when I tune the second vfo from 0 to 1000. ? ? I hope all this is making some sense and helping!!!
Also checked to make sure that VR102 is not full on. It's at it's aprox. mid point.
I believe the HG is dead. I did as you suggested with a SW SDR and I do not detect any signal at all tuning up and down, and putting the scope on TP106? the output from the HG shows nothing. It is getting the 9V supply
Is there a process to check the crystal?
I really appreciate your help with this..
