开云体育

did you try setting your audio to mono on your computer?

Ran the FTDX10 remotely also. Audio settings on PC were tricky, but worked. While on my home network (ham shack is 100 yds from my house) everything always worked, but over the internet, no

Thanks Don.?The problem I am having is running the Yaesu FTdx10 remotely. The problem is what I only have audio coming out of one speaker on my laptop, not both as it should be. I have tried

Well Duane I don't think you will be able to help me with the issue I have.The problem I am having is running the Yaesu FTdx10 remotely. The problem is what I only have audio coming out of one

I found this thread in another group: /g/ftdx-10/topic/auto_tune_memory_clear/101993594 ( /g/ftdx-10/topic/auto_tune_memory_clear/101993594 ) It appears that you

switch to a different antenna entirely and tune that and then switch back and tune again.

Dear OMs, I work my DX10 with an EFHW on 40/20/15/10m and a 1:64 Balun. Tuning was working fine for a while and I had rapports 55 to 59 within Europe. I never saw the "High SWR" warning in the

If you don't have one now, just sit quietly and wish you had kept it.

Certainly. We are a small group here with 136 members, but post your question or issue and we'll see if anyone here can help. If we can't help you contact me off-list and I'll send you some other

used to own one. What is the help needed ? <w6mtm@...> wrote:

Can I get help with FTdx10 issues on this page?? Thanks, Bob? W6MTM

hi, there is standard a 500hz cw filter in the second if, 8,83mhz most it be activated or can be deactivated per? menu, or is it all the time present in cw mode, i have the radio only since few

The microphone cable on my FT-8800 has given up the ghost, and no longer works properly. The insulation has worn out, exposing bare copper. Does anyone have experience replacing the cable only (YAESU

HF + VHF + UHF Transceiver, Power Supply, Manuals, and more For Sale: . Yaesu FT-847 HF+++ Transceiver: The Yaesu FT-847 changes base operation forever. Now you get three radios in one -- HF,

When switching the unit on/off the S/RF meter momentarily deflects and TX RX momentarily light up. Is this normal?

Thanks Gary, was looking for a CPU data line rather than turning down the CW sidetone aswell with that trimpot method.

I gathered the information from page 7 of the user manual- Gary

Look at page 30 of your manual. Section 4.5 keypad beep volume

Thanks Gary but there is no 'dual function" associated with this transceiver, you must be thinking of a different transceiver.

When a dual function option is disabled, it stops beeping when used, to indicate that it has been turned off. Hearing a beep indicates the function is enabled. If beeping was to be turned off (some