开云体育

I'm having trouble getting my DR5013 out of DEMO mode. I tried with 3 different USB cables Even with the DR5013 connected to nothing else than the PC the? COM port shows? correctly on the device manager as? "DR5013 reversloop controller on DR Command" but cannot get out of DEMO mode.
I was considering starting with a "clean slate"? by forcing a re-installation of the firmware V1.1.0? Is there a way to do this?

Press and Hold the Pol. Button on 5013.

then Plug in USB and start the software. Gi directly to USB and click Update.

Great Thanks Will do !

Done,? but still no connection; still stuck in DEMO mode.! ? When I Hold the POL button should there be a change in the green /blue LED frequence ? Because nothing happens in my DR5013

No,

?

Only added bootloader LEDs in the YaMoRC products ;)

?

When doing the Procedure as described, the LEDs stay all off. When holding the button and then plugging in the USB, you should hear the USB-insertet-riddle and a Atmel or Lib-USB device should appear in Device Manager.

?

Greets,

Karst

Problem solved! Thanks

Following Karst suggestion I was able to re-establish connection with the DR 5013
Then I modified the settings as you recommended :
1) decreased the short circuit delay ( from 200 ms? to 50 ms in both DR5013 and DR5000),?
2) changed? DR5013 "Report short-circuit" from BOTH to NONE
Now thanks to the help of you all I can run trains with Rocrail in AUTO mode again