Hi Guys,
?
I have several DR4018's run from a YD7001. I cannot get one of the 4018's to stay in programming mode. I can push the button and the red light comes on, but when I release the button the light goes out. If I can't get the light to stay on I assume I can't reset the unit or program it. I have a 200 ohm resistor between C and 1 as per instructions!
?
Is now a brick to be consigned to the waste bin, or is there a way to reset it? I just don't like throwing out something that could be recovered.
?
Thanks
?
Pete S.
