You are not ¡®tying¡¯ the 1-8 outputs (or 9-16) together, they remain completely separate as they are today. You are placing a shunt resistors between the feedback e.g. feedback 1 and the C terminal for that bank.?
This means that most of the current shunts through the resistor rather than going through the DR4088xx.?
[Edited Message Follows]
Ryan: I have read about adding resistors to the DR4088 to desensitize the device but never understood how this was to be accomplished until I saw your photos. Awesome, thanks!!!
Just to help me understand further, though, it was my impression that each of the 1-8, 9-16 detection connections were to be separate from each other; ?the way you have them soldered together to the common ¡®C¡¯ is they are all tied together, will then a detection on any one them show detection on all of them, thus making it a tad confusing as to which block is occupied?
