?
sometimes you need to just hold things in place with
plastic clamps or maybe temp cable tie in place to stop moving.
also first job is to velcro it around the vertical finn
tube
?
I have posted below the instructions from my build manual
it might help
?
Seamus
?
Drape the cover over the
fuselage, join it up at the back first with the Velcro after passing the rudder
cables and elevator fork/trim cables through the holes.?
?
Fit the support battens 330307A,B, C & D into place,
330307B doesn’t fit into a pocket it locates on the side brackets see B16D.? 330307C locates into a little pocket and
then hooks into an attachment at the fin LE see B16C.
?
Start to loosely lace the sides and top of the cover in a zig zag
formation, but do not tighten, you may also use cable ties for this if
preferred.? Attach tube 324 (shown
in B16).
?
Lace up the bottom of the
cover starting at the back, working your way forward, time will need to spent on
this to get it nice and tight.
?
Continue lacing up the sides and top until the fabric is tight.? You will find that after a few days
further tightening can be achieved.
?
?
?
?
----- Original Message -----
Sent: Wednesday, July 27, 2016 2:12
AM
Subject: X-Air Ultralight Aircraft
Ottoman Fuse sails
?
Still struggling on the fuse sails..
When we get one end or side lined
up the other is off.
Then I can't seem to pull the bottom together . Never
been so frustrated . I have pics but I'm not sure how to put them on here. Is
there aomething were missing her or were the sails just poorly
made?
