开云体育

Thanks Doug.? I just sent them an e-mail this morning, so perhaps they can offer some possible solutions. I think my best bet is to buy an official Xiegu USB/Serial cable, and then if that doesn't

Have you asked Radioddity Support for help? They're pretty good. -- Doug, K8RFT

Hi Everyone, I just got a, X5150 at a hamfest, and it was working fine until I decided to update the firmware.? Nowhere in the instructions did I see a warning that simply entering the bootloader

Brain storm , remove signalink from the equation , din pin 4 yellow AF out and din pin 7 violet wire GND to trs stereo cable spliced to give two cables L+R connected , plugged into ground isolator and

Extra Infos and setup http://www.tigertronics.com/pgmsetup.htm Edit : here is what i am getting so far after setting JP1 pins 1:1 and wiring cable SB1+ is getting Power from Blue Din Pin 8? -

Here are my thoughts now : *8 Pin Din Cable* pin1 red - PTT Pin2 Brown -Band Pin 3 Green- AF in Pin4 Yellow - AF out Pin5 Orange - ALC Pin6 Black -Data Pin7 Violet - GND Pin8 Blue -8V+ *SB-1+

I have noticed the same "background hiss" since day one and it seems to be more noticeable with headphones on. My guess is that it is something inherent to the audio amplifier stage as the filtering

Thanks!? I had not seen that before. -- Doug, K8RFT

"How did you get on with this adapter ?" - Actually, I'm sorry to say that I still have not tried it. The uncertainty of the PTT compatibility, and possible damage to the X5105's 8 V. mic bias supply

Great video , i used CC and auto translate to English ;)

Thanks for this infos , especially the Line out and out setting for data port , i am making my own cable for my Signalink SB-1+ and that would really have threw me lol

This may help setup your RSP1a as a panadapter http://www.sdrplay.com/wp-content/uploads/2017/10/171011PanadapterGuide.pdf pay attention to page 23 for IF out setting

JP1 inside Signalink , i forgot to say make sure u enable line in and out in menu

pin1 on Signallink is Speaker Pin2 is " Mic Pin3? " PTT Pin4 " PWR Pin5 " Not Connected Pin 6,7,8 are Gnd Inside the signal link there is a jumper system to match different Mics , just remove and

How did you get on with this adapter ?

Same here , i even purchased a ground loop isolator to see if that would help but nope , to be honest i dont really hear it when i have volume up but i defo noticed it there when i put power off and

X5105 for sale My X5105 was purchased from HRO consignment.? I intended to use it while traveling, but it has not been used after more than 2 years.? When I bought it, I powered the radio up a few

I found this feature too. It will even send a message memory in CW, PSK, or RTTY. But there is no loop back from the message audio to the transmitter on PSK or RTTY. What you can do is hold the

https://github.com/Botspot/wor-flasher ;)

Hi all, well.. I like the PSK31 decoding function, but how to make a qso in PSK without extra PC? Main message can be pre-programmed as memo, that is fine. Only thing is, if you want to answer a CQ,