开云体育

Dave, Why do you say that the frequency is too low for unattended use. I am planning to setup a Trimode station that runs VARA/HF on 80 meters during the daylight hours. 73, gerry KK7GAB

Have you tried ticking 'Use Internal Sound Card'? -- Kevin k5vp

Another advancement: In VARA HF WinLink Settings I changed the “PTT Serial Port To Use” from CI-V to ICOM7300 Next, I need to figure out how to get the message in my outbox to its destination.

Yeah, that’s too low a frequency to put an unattended automatic station. -- Dave WB7WHG

Tnx! Found a video on setting up the IC-7300 and VARA/Winlink. FINALLY got things running, with one glitch. When I run the Test in Vara Setup I still get the red box. Other than that, the laptop is

Winlink Express is free (recommended). [email protected]> wrote:

Before I go any further, do I need to purchase Winlink or Winlink Express?? Sent: November 15, 2024 6:18 PM To: [email protected] Subject: Re: [VARA-MODEM] Problems - Vara Modem and Winlink Express

You would need to make sure the TCP or Virtual Command Port is the same for VARA HF and in the Winlink Express VARA TNC setup. Mine is 8300 but 8310 should work as well. 73 John Denison KD5YOU

WSPR frequencies have been published and used for many years.? Putting a gateway on top of WSPR would be like putting a gateway on top of the FT8 frequencies. W

The KB6HOH-12 VARA Gateway on 3570.000 kHz is useless due to QRM interference from multiple WSPR signals in the range 3570.000 to 3570.200 kHz.

One Vara needed changing as per a tipi from Jose. Still didn’t work. Something is still off and Bara/Winlink aren’t shaking hands.

Thank you! Getting close ? Next, I need to find where I can change that?? Sent: Friday, November 15, 2024 9:48 AM To: [email protected] Subject: Re: [VARA-MODEM] Problems - Vara Modem and Winlink

All of my settings are either using localhost or 127.0.0.1. That needs to be in Vara *AND* Winlink, otherwise they will not talk to each other.

RMS Trimode has been freezing up on a lot of RMS computers since the latest non-beta update. Your issue resembles what we've seen with connections to those affected RMS stations. A new beta version is

It could be that an update came an changed something related to the sound card, I'd start looking there.? I've had Windows updates take down my Winlink gateway before :( Hope this helps

Put down the tonic, Dr. Jekyll. 73, K1CPR Juan [email protected]> wrote:

This is not ME. I did not sent this. I know what SNR is Sent: Thursday, November 14, 2024 11:05 AM To: [email protected] Subject: Re: [VARA-MODEM] VARA HF signal to noise ratio issues SNR is signal

SNR is signal to noise ratio. Sent: Thursday, November 14, 2024 10:35 AM To: [email protected] Subject: [VARA-MODEM] VARA HF signal to noise ratio issues I'm having a problem with the SNR. The SNR

I'm having a problem with the SNR. The SNR is always in the Red, typically -19db or so. When I monitor the signal, it is very strong so I'm not sure why this continues to be an issue. I'm running an

I do have Winlink installed. That said, your suggestion to review the setup video was a good idea. I found settings that were different. Still not working, so will review it again. The one thing that