开云体育

OK, I just switched back to the DR-135 and it connected as usual and moved data. The VU meter was in the upper half of the green (-12) for the entire session and did not go to zero afterwards. With

No, squelch closed and meter is at the bottom. With a signal and audio heard in the speaker, metter is in the lower part of the green. Looks like it's not over driving. Do you want me to open the

Bob, I'm assuming you mean zero as in 0dB (needle in the red) and the squelch is open.? If so - try lowering the receive audio level with no signal - to around -10 dB on a dead channel with no

This will depend whether you are using a normal speaker-like output where the radio remains squelched between signals (where you will see nothing on the VU meter).? If you are using the "9600 baud"

Kevin, Yes, Auto Tune gives increasing volume on each of the ten succeeding steps. The VU meter sits at zero with no signal. Tuning to a weather channel, the VU meter bounces into the lower green

I have tested end-to-end VARA-FM FAST links with a pair of FTM-6000s and they work perfectly.? Effortless connect at 22K-plus speeds.?? I have had a mix of SignaLinks, DigiRigs and my homebrew

FTM--6000 works great for VARA FM Wide using a DRA-50. Don't know about Digirig.

Yaesu FTM-6000. Kevin W3KKC

That’s fine used on qrz 73 de K3FZT/Steve --Steve Davidson K3FZT Winlink Gateway K3FZT-10@... direct or via W3EOC-3 Supporting VARA FM Wide/1200bd Packet WIRES-X Room #85218 “MARC-DARBY”

FTM-6000 find knew on qrz.com for ~$250-300 73 de K3FZT/Steve --Steve Davidson K3FZT Winlink Gateway K3FZT-10@... direct or via W3EOC-3 Supporting VARA FM Wide/1200bd Packet WIRES-X Room #85218

Let's say under $400 -- The Reverend Thomas Heard fr.thomas.heard@... +1.314.650.5010

Can you put a dollar amount on "not-to-expensive"? Mark - AD7EF

Bob, Can you confirm that when the TYT transmits the Auto-Tune you actually hear 10 different levels of volume from the monitor receiver? Also - where on the VU meter does the receive audio level

Thanks for that. Any suggestions for a not-too-expensive VHF that would handle VARA WIDE?

Unfortunately, the Chinese made Alinco radios no longer have the DB9 interface for wideband audio..The DR-135 was the last of the made in Japan Alincos before they folded and TYT acquired the name and

Keven, I just ran Auto Tune on the DR-135 and it works correctly, I can hear the audio volume increasing in steps on another radio and then I get the APPROVED banner. Same interface on the TYT Auto

Bob, Please do the following and report back: Using another radio to listen to your transmission from the TYT TH-9000D, initiate an "Auto Tune" from within VARA FM making the TYT radio transmit.?

Keven, Thank you for your detailed response. I apologise for hijacking this thread, so I'll contact you directly for any followup. You are correct that the receive audio should be on pin 2 and I

Hi, I'm looking at the above as the radio for a new Winlink Gateway. I'd use a Digirig Mobile as the interface. Is it capable of 9600 on Vara FM? Any thoughts on this application? Thanks and 73

Bob, I see that you responded to the wrong thread this morning - so I'll assume you're still having the issues. The RIM products are not mine <https://www.repeater-builder.com/rbtip/whoisrb.html> -