开云体育

I actually do have a remote antenna for my Baofeng, so hopefully, it will work ok. Thanks, and 73, Dave KJ7WT

Before giving up on the Baofeng handheld, try using a remote antenna and at least 10 feet of coax to position the antenna away from the Baofeng. I have had acceptable results using an antenna located

Ok, thanks for that info! As mentioned, I've used VARA HF with RMS Express, and have been frustrated trying to find a reliable HF link. There are a couple of 2m? FM nodes nearby, and even if the

The AIOC has hard PTT keying via the PTT line.?? You should be disabling any VOX in the radio and it' associated delay.?? (The VOX was intended for voice operation, and has delay on unkey to avoid

Hello All, I am expecting to receive an AIOC interface in the next few days, after un successfully trying to use simple audio cables to my Baofeng hand-held. The VOX in the radio "hangs" for quite a

Bob, For a few reasons - it's best to open the squelch (wide open) for VARA FM communications.? So - open the squelch and set the VU meter to -10 -11 or so on a dead channel, and try again.? The

OK, I just switched back to the DR-135 and it connected as usual and moved data. The VU meter was in the upper half of the green (-12) for the entire session and did not go to zero afterwards. With

No, squelch closed and meter is at the bottom. With a signal and audio heard in the speaker, metter is in the lower part of the green. Looks like it's not over driving. Do you want me to open the

Bob, I'm assuming you mean zero as in 0dB (needle in the red) and the squelch is open.? If so - try lowering the receive audio level with no signal - to around -10 dB on a dead channel with no signal

This will depend whether you are using a normal speaker-like output where the radio remains squelched between signals (where you will see nothing on the VU meter).? If you are using the "9600 baud"

Kevin, Yes, Auto Tune gives increasing volume on each of the ten succeeding steps. The VU meter sits at zero with no signal. Tuning to a weather channel, the VU meter bounces into the lower green

I have tested end-to-end VARA-FM FAST links with a pair of FTM-6000s and they work perfectly.? Effortless connect at 22K-plus speeds.?? I have had a mix of SignaLinks, DigiRigs and my homebrew

FTM--6000 works great for VARA FM Wide using a DRA-50. Don't know about Digirig.

Yaesu FTM-6000. Kevin W3KKC

That’s fine used on qrz 73 de K3FZT/Steve --Steve Davidson K3FZT Winlink Gateway K3FZT-10@... direct or via W3EOC-3 Supporting VARA FM Wide/1200bd Packet WIRES-X Room #85218 “MARC-DARBY”

FTM-6000 find knew on qrz.com for ~$250-300 73 de K3FZT/Steve --Steve Davidson K3FZT Winlink Gateway K3FZT-10@... direct or via W3EOC-3 Supporting VARA FM Wide/1200bd Packet WIRES-X Room #85218

Let's say under $400 -- The Reverend Thomas Heard fr.thomas.heard@... +1.314.650.5010

Can you put a dollar amount on "not-to-expensive"? Mark - AD7EF

Bob, Can you confirm that when the TYT transmits the Auto-Tune you actually hear 10 different levels of volume from the monitor receiver? Also - where on the VU meter does the receive audio level ride

Thanks for that. Any suggestions for a not-too-expensive VHF that would handle VARA WIDE?