开云体育

Exactly, and the response of the motor is an important part of feeling what the lathe is doing. A speed readout is just a distraction. Old industrial production machines used an Ammeter to see how

Great stuff. I don’t know if you dabble with electronics but I also made a simple speed readout using a Hall sensor, an Arduino board and a small display. The Hall sensor detects magnetism, so you

Thanks Peter, just been and ordered two of these. Phill

PWM (Power Width Modulation, I believe) controllers are readily available online… the ones I got (I have two motors also) have a three way rocker switch (forward, off, reverse) and a potentiometer

Thanks to all for the information, I have not been able to find a pdf of the motor spec's, why I asked the bench supply has a max of 30v so I am winding it down to 24v to use the lathe and wondered

Hi Phill, These motors are designed to be powered by a battery pack constructed from lithium cells with a nominal voltage of 3.7 volts per cell. 6 cells would only provide 22.2 volts so would

John, I agree totally. Don’t mess with the voltage it works perfectly at 24V -- http://www.homemadetools.net/ forum/ OFF- SET-tailstock-center-65965#post105972 http://www.homemadetools.net/

To keep answers simple, take off the plastic tube and use something like a mesh.? Motors do radiate a certain amount. Now run the motor as you state.? Touch the end.? If you feel that you are going

Fasco has several PDF documents with spec tables on many of their motors. Try googling Fasco dc motor specification PDFs. As a general rule, dc motors are quite forgiving with voltage

Sorry John I was a bit quick at asking. It is a Fasco 24V DC? made in Canada? product No 2809-850-014 there are no spec's on the plate to tell me amp's, wat's, etc; . And yes I have fitted it onto

First, we must assume that the discussion is for 24V scooter motors used on Unimats. That being said, who here can tell us about burning out one of these motors while in use on a Unimat.

Could anyone advise what could you safely overvolt a 24V DC motor please. Phill

Hello Ed, I forgot to ask you it your dials are metric or imperial. Dick -- http://www.homemadetools.net/ forum/ OFF- SET-tailstock-center-65965#post105972 http://www.homemadetools.net/

Thanks, Ed I am looking forward to seeing what you have. Dick -- http://www.homemadetools.net/ forum/ OFF- SET-tailstock-center-65965#post105972 http://www.homemadetools.net/ forum/s...995#post112113

I found the supplier I got my handwheeels from.? They fit snugly over the METAL handwheels of a unimat.? I believe they may be 3D printed? I have them in Black numbers and marks on White,? he

I have used Mert’s Method on my Mini Lathe many times and it works perfectly! I bought a bolt with the correct pitch and will use it on my Unimat DB200 and intend to make a hand

Thanks Keith I finally located the photos! Dick -- http://www.homemadetools.net/ forum/ OFF- SET-tailstock-center-65965#post105972 http://www.homemadetools.net/ forum/s...995#post112113 (

It's in Photos, Mert's Mods - don't forget the apostrophe.

/g/Unimat/album?id=195802 You’ll need to log in to groups.io.

I was not able to find Merts Mods in the files section or photos. Perhaps I am missing something. -- http://www.homemadetools.net/ forum/ OFF-