开云体育

Carl <carl.blum@...> added the photo album Cut-off Blades ( /g/Unimat/album?id=299104 ) : Two cut-off blades

Sent: 23 November 2024 18:51 To: phill005; [email protected] Subject: Re: [Unimat] Mistery Unimat 3 with interesting modifications When I changed over to DC motors I built the controller box with two

I had the standard U3 power feed attachment but didn’t much like it… When I changed over to DC motors I built the controller box with two PWM units (the transformer had two 24V DC outlets anyway),

Many thanks Bill now a member. Phill

Sent you an invite to your email address. Bill in OKC? William R. Meyers, MSgt, USAF(Ret.) Aphorisms to live by:Good judgement comes from experience. Experience comes from bad judgement.?SEMPER

Hello Bill, could you send me the details to join Mini-Mills group please. Phill

Hello Julius, The gear box on this U3 is powered from the head spindle with a rubber belt and it has a disconnect on the end of the box you push it in to drive, pull out to stop, so you have full

Look at the Mini-Mills group, which I own, and can send you an invite to join, if interested. They have a few things about add powerfeeds to mills, which can be applied with a little skull sweat to

Hello: @Phill005 Yes, so do I. But it is rather a hassle to use. Belts (o'rings actually) stretch too easily and slip, interrupting the cut. Even if you use the right OEM spec. ie: 2-222/N674-70 Are

Saw blades for the Unimat fret saw are available in most big box stores such as Menards and Home Depot. ?Also known as coping saw blades. Dick -- http://www.homemadetools.net/ forum/ OFF-

Hello Neil: I received Clive's files but I checked and yours are perfectly accessible. No problems. Thank you. Best, JHM

Hello Clive: Yes. And received perfectly. Thank you for that. Best, JHM

Neil,? many thanks for the link to the mags, this is something I have been interested in doing for my U3 that i am restoring although I do have a Emco power feed on mine but you have to change the

You can't download them? Neil [email protected]> wrote:

Hi Clive, I would also be very interested in a copy of these articles if that is possible please?

John, I understand your approach to tooling and that works for you and is great. I on the other hand enjoy grinding tools and making cutters. Different strokes for different folks. The only cutters I

If I've done it right you should be able to download both mags here. If not, I'll have to try again!! The link expires on Nov 29th. https://k00.fr/fdpjl7om Neil ----- [email protected]> wrote:

Sent!

Hello: I meant to write sawbona@ ... ( sawbona@... ) Best, JHM * why can't we be allowed to edit our posts?

Hello: That would be wonderful 8^D ! My address is sawbona@.... Thank you very much. Best, JHM