开云体育

I see is clocks and watches Here a chart for the mini rotary table 36 tooth worm and cutting a 59 tooth moon phase. The second file is for simple indexing 3, 4 ,5 and 7 indexing drum Dave

It is current you have to watch for and cooling Some will put current limiting resistor and a threamal switch. The rule of thumb on motors max 10% over voltage. I have always like this lathe A year

Buy extra pins that size, then. You'll likely chew them up getting them out if you do it frequently.? Bill in OKC? William R. Meyers, MSgt, USAF(Ret.) Aphorisms to live by:Good judgement comes

To add to my last comment about tapping a dowel for removal, standard dowel pins are only case hardened so they can easily be drilled and tapped. Dick -- http://www.homemadetools.net/ forum/ OFF-

Peter, I have tapped dowels to allow them to be removed. Dick -- http://www.homemadetools.net/ forum/ OFF- SET-tailstock-center-65965#post105972 http://www.homemadetools.net/ forum/s...995#post112113

Many thanks everyone! My immediate (and very temporary) use is to register the fingerboard on a classical (nylon strung) guitar before removing and re-shaping it (and the neck). I’ll be adding some

Peter, Straight dowels will likely give you all the accuracy you need. Since wood changes size with humidity and the seasons, one usually needs to allow for this by locking two pieces together at

There are two ways to use dowels for location. The traditional way is to assemble your mechanism, or whatever, and when it is right drill and dowel the joints so it can be dismantled and rebuilt to

Hi Peter: McMaster-Carr has a excellent online catalog, and will ship overseas. I think they would get you good rates. Also they sell dowel pins with tapped holes so you can pull them from blind

Thanks Dick, I’m in the UK though… I can see a blind hole being a problem for a pin that is tapped all the way in - to fix a handwheel for instance. My purpose would be to repeatedly locate two

Good call I forgot to mention that. Phill

A blind taper pin cannot be removed. -- http://www.homemadetools.net/ forum/ OFF- SET-tailstock-center-65965#post105972 http://www.homemadetools.net/ forum/s...995#post112113 (

Peter, look at MacMaster Carr for taper pin reamers and taper pins. This is a great source and they have anything. Dick -- http://www.homemadetools.net/ forum/ OFF-

Brilliant, thanks Phil, just what I needed.

Yes no problem pre-drill a hole to depth then use the reamer to depth, you might have to do a test cut in some scrap to achieve a snug fit for the pin as you don't want the pin to bottom out. Have a

Thanks Phil. Is it possible to make blind tapered holes? The broaches I’ve looked at on clockmakers sites have angular points (as you have), but I see you also have what looks like a tapered

This is something I have been using for years on many different projects from clocks to holding small plates whilst cutting out shapes in metal, wood, plastic on a panto-graph mill they range from

Hi Gang: The tapered drift handles on spud wrenches are not quite the same. They do align the holes enough to get a rivet or bolt in, but do not provide the precision location a tapered pin in a hole

Podge or a podger spanner in UK - Australian parlance if you need an extra search term. Yahoo Mail: Search, organise, conquer

Thanks Davis. Yeah, I might have been guilty of using a screwdriver in a similar (if not remotely accurate) manner to get larger things ‘more or less’ aligned!