Re: 24V DC motor #unimat3
|
It is current you have to watch for and cooling?
Some will put current limiting resistor and a threamal switch.?
?
The rule of thumb on motors max 10% over voltage.
?
I have always like this lathe?
A year ago down size to but when to mini lathe and planing a DC power feed on my mini lathe it too is 12 volts .
Here the one purchased?
?
Dave?
?
This wath just putting on my mini lathe a mini rotary table and chuck.?
That table is 3" and chuck 48mm?
?
?
FYI I only this I this first post years?
I spend most the on minilathe?
On Sat, Jan 25, 2025 at 07:03 AM, phill005 wrote:
|
davesmith1800