开云体育

I searched again on the part number -?MIFLEX KSPPZ-10-2. That leads to lots of suppliers in many countries, but this site gets you to the data sheet:

Hello Elliot: I checked my Unimat (1972) with a 0.00005" indicator and found the headstock / tailstock alignment very good. I have the numbers at home in my lathe book, but the headstock pin was as

Some eBay items are only available via a specific country. If you need Unimat items for example, it's worth trying eBay Germany and asking the seller if they'll ship. However these caps are very

Yes here it is: eBay item number: 232903251844

Apologies - the Ebay code that was mentioned for whatever reason does not get me anywhere. Could either of you perhaps share the German supplier's website with a link to the specific item? Many thanks

Loosen off the head stock and the tail stock clamp a bar in each chuck then lock the head and tail stock take out the bar and try a cut. Phill

Many thanks all, I was speaking with a guy yesterday he said have a look in an old electric pistol drill you might find one there, but if not have a look on e-bay and he directed me to the same German

Just looked again and found Ebay item?223653993396. That's the sort of thing I used before. The listing is from Germany, but the type may get you to a local supplier.

when I looked a few years ago I couldn't find a modern version that would fit inside the motor. I had to fit one outside, and made a cover for it. The only small ones I can see now are rated at 100 V

It's not critical. The motor will run okay without it but you'll mess up radio reception around you. Just get one that fits with the right number of wires and the right voltage ratings. Neil Morrison

As Scott says, the head stock likely needs adjustment. How are you aligning the head and tail stocks? You can't rely on just the locating pin. That is only approximate. -- Elliot Nesterman

Hi, What about slightly rotating the head stock? Scott Sent: Tuesday, June 20, 2023 11:30 AM To: [email protected] Subject: [Unimat] Unimat SL1000 adjustments. Hello friends! Just curious if there is a

Hello friends! Just curious if there is a way to adjust the tail stock so it drills straight thru a brass rod. It appears to be drilling on a slight slant. Any direction on this would be appreciated.

The markings on my capacitor for the U.S. market motor are: N 1022 R/1 0.01 uf + 2x 2500 pf @ 220V HPF 65.8 560-2-7 Scott Sent: Tuesday, June 20, 2023 5:01 AM To: [email protected] Subject: [Unimat]

Can anyone tell me which motor suppression capacitor I need for my Unimat SL please?, It has started blowing the mains switch fuse and I find I need to replace the capacitor but on the one in the

Thanks Keith, that’s really useful information and opens up some distinct possibilities. A Googling I shall go!

Somewhere I have a set of change wheels for inch threads on the Basic (also a 1 mm pitch lead screw) and clever things are done using 17 tooth wheels. It gets very close to the correct pitch - last

TO SMJ Thank so very much for this fantastic? 3d solid model with all details . I have extracted the Unimat 3? basic parts? from the complete file without problem . Thank You again SMJ for make

Hi , I found as solution , please find a zip file with the accis solid? core in SAT version 7 format Best Regards Lars

Hi SMJ I use the Unimat 3? as a? 3d? jig holder? and my jig is in a 3D solid format using? my 3D program , but it should b great to also? have the whole? thing in the? 3D !! I have a 3D