开云体育

Hi Eugene That's a very generous offer to make but best hold on until we hear back from Martin as to how the payments he has made have been funded. I hope he will reply in the next day or so, but I

If the annual fee has not yet been paid, I would like to pick up the tab. If the annual fee has been paid so as to render us current, I'd like to reimburse the person who paid the fee. ?I'm

Good to see you made it! I'm pleased my pestering has paid off, but it turned out to be just a matter of getting through to the right person, and that was done by others. Now that the problem is known

Keep us posted on what you find out. I have no problem donating some money to keep this group going. Will we still be using Paypal??Jeff

Hello all members I wish to advise you that the annual $220 group fee has been paid by Martin. I have emailed Martin to enquire if he funded this personally or were there sufficient funds over from

Hi Frederico You were approved for membership back in July which is the reason you were able to post pictures in the Photo section. Looking forward to your input to the Group. Marcus

Hi Ian You have been a member since?16/09/09 with your current email address, before that time you were a member using a different email address from which you have never posted as it is still set to

Hello, Ian here. I was the one who wrote to Keith (thank you so much, Keith) as a desperate attempt to be able to post on here. And also a huge thanks to all the others who contributed to help to

Hello I subscribed the group about one year ago but??I was unable to joint the discussion for this problem. I hope now to be part of the community. Best, Federico.

Hi Neil No he is not an owner or moderator. Marcus

BTW, I thought birkyguy AT metacrawler.com. was the owner but his email is bouncing too. FWIW Neil -----

I run a few (very quiet) groups here so you can add me as a backup too for worst case scenarios if you wish Neil

Hello again to all members This evening I received an email from a new member whose application to join the group had not been authorised, this really is a cause for concern as reading the posts it

Good afternoon, I too have been trying to join this group for a couple of months without success, my first post is still at New Member Moderated. Looking through the records it appears that Martin

Good morning Keith, I too have been trying to join this group for a couple of months, and have my first post stuck at New Member Moderated. I also have had no response whatever to various attempts to

Wow, I only have 3 lathes, although I'd like to get a small native metric machine for threading.? I'd like to say that I don't have the disease, but then I'd have to ignore my collection of

Before the Yahoo group shut down and before switching to groups.io, I downloaded all of the posts and pictures in case the group did not change over. But a lot of water has gone under the bridge since

This will be fun to follow. I'd recommend buying some soft metal drift rods and a socket set, and cleaning as much gunk from shafts before driving them thru a casting though. I was cringing when he

The sixth lathe is the one where you know you have enough. Don't ask me how I know. Neil [email protected]> wrote:

Has anybody tried emailing xpylonracer@...? They are an owner and were active in GIO as recently as late October, but it doesn't seem that they are engaged with this particular group. There are