¿ªÔÆÌåÓýActually Andrei, I have a rather large number of reference books on a wide variety of subjects.? They happen to include Machinery¡¯s Handbook, so perhaps it is just easier for me and many others ?to have the specific information we use most often condensed down to just a couple of easy to read pages rather than having to look through a whole reference book to find a particular fact printed in legalese in miniature type. ?? ? Jerry F. ? From: [email protected] [mailto:[email protected]] On Behalf Of Andrei via groups.io
Sent: Monday, February 10, 2025 10:15 PM To: [email protected]; gfeldman2904@... Subject: Re: [Unimat] Charts & Tables for Machinist's ? Don't you guys own a Machinery's Handbook?? ? It is available in print or digital. No need to blow up and file tables. ? I have a copy at my desk and one in the shop.? ? The shop one is grungier. When becomes hard to read, I will buy another. Ebay is full of them under 30 bucks and replacing a book every 5 years will not bankrupt me before I die. ? If you get the digital one, you will have to either clean your hands or use a stylus on the tablet. Works OK, but I prefer paper, and I bet that most of you would prefer paper, too. ? Get From: [email protected] <[email protected]> on behalf of Gerald Feldman <gfeldman2904@...> ? Dave, ? The ¡°direct link¡± you posted will only work for a member of that group.? I¡¯ve looked through all the e-mails listed in the group which was a waste of my time as your link simply does not work!? You personally can see and use it because you are a member of that group but I already am a member of too many groups and do not wish to join yet another. ??Why can¡¯t ?you just post them to the Unimat group so everyone in our group can get to them? ? Thanks, ? Jerry F.? ? From: [email protected] [mailto:[email protected]] On Behalf Of davesmith1800 ? Here a direct link /g/minilathe/files/5%29Charts_&_Tables ? Dave? |
