Re: Edelstaal cutoff or slotting tool and Komet toolholder
|
Thanks for the photo, Peter, I will try this on my Unimat then. The G-clamp is cut, I will try and see if one of my machinist¡¯s clamps fits. Thins up, Herman
? Van: Peter Brooks <peter@...> Verzonden: zondag, november 10, 2024 11:02 AM Aan: Herman de Leeuw <herman.deleeuw@...>; [email protected] <[email protected]> Onderwerp: Re: [Unimat] Edelstaal cutoff or slotting tool and Komet toolholder ? Hi Herman, it's just the standard U3 toolpost, with a tiny (and very cute) 'G' clamp.
?
This photo is roughing out 'steps' in an aluminium pulley before further turning (I know, I know, as others have already mentioned I could have just used a v groove...). I could zoom in to the original, larger version and it looks like the teeth are still there, at the top cutting edge. I think I did this presuming that area is definitely hardened and best for cutting.
?
The arrangement is pretty 'Heath Robinson' - but it works! :)
?
?
(Moving the motor to the other side allows mounting of an indicator on that side)
?
|
Herman de Leeuw