Hi Dick:
I cut off a
CAT40/ER32 holder and welded in a bushing for M12x1:
/g/Unimat/photo/195716/2246540?p=Name%2C%2Cer32%2C20%2C1%2C0%2C0
With a little
fine tuning it works fine. I really like it for wood since its
range is large and it doesn't leave jaw marks.
Also it can
hold any size milling cutter.
Carl.
On 9/21/2024 9:43 PM, OldToolmaker via
groups.io wrote:
toggle quoted message
Show quoted text
I have a full set of ER32 collets and a collet nut. I want to
use them on my DB200 Unimat in lathe mode. The only lathe I have
at this time is my Unimat.
As I see it my best option is to single point thread a new
Unimat spindle nose to fit the ER32 collet nut I have. I have 6
Unimat spindles So that should be no problem.
Does anyone in the group have any suggestions that might be
better than what I have proposed?
Dick
--
forum/?OFF-SET-tailstock-center-65965#post105972
?SMALL TURRET TOOL POST
PLANS?
?LARGE TURRET TOOL POST
PLANS
?MINI-LATHE CARRIAGE
LOCK PLANS
?SMALL QC TOOL POST PLANS?
?QUICK CHANGE LATHE TURRET
?MINI LATHE COMPOUND PIVOT
MODIFICATION
Carl