Hi Bill:
The lathe dog
is for turning between centers, the most repeatable clamping on
a lathe.
Carl.
On 5/12/2024 11:10 AM, Brad Barton via
groups.io wrote:
toggle quoted message
Show quoted text
On Sun, May 12, 2024 at 07:57 AM, Bill in OKC too wrote:
Faceplate
& lathe dog are used together for turning between centers.
That gets you the most accurately made parts your lathe can
make.??
?
I'm trying to wrap my brain around the need for the lathe dog,
doesn't the chuck do a good enough job holding the stock?
The next question that comes to mind is the tooling, should I
buy new tooling. It came with a lot but I don't know the
condition any of it is in. I might take a picture of just the
tooling and get some help of what I have and the use of each
type of tool.
Carl