Look in files. Drawings are there for the factory t-slotted table & a table with drilled and tapped holes on a grid.?
https://mail.yahoo.com/m/36/edit/3621468074
I made one of each.?
Bill in OKC?
William R. Meyers, MSgt, USAF(Ret.)
Aphorisms to live by:
Good judgement comes from experience. Experience comes from bad judgement.?
SEMPER GUMBY!
Improvise, Adapt, and Overcome. Physics doesn't care about your schedule. The only reason I know anything is because I've done it wrong enough times to START to know better.
Expect in one hand, expectorate in the other. See which one gets full first.
On Thursday, May 4, 2023 at 09:49:20 PM CDT, David James via groups.io <davebjames@...> wrote:
I am trying to make a milling table for my unimat from a piece of cast iron. The dimensions I get off photos on Ebay just don't look correct. Does anyone possibly have the dimensions of the table?, especially the distance between the T-slots and of the hole distances. I have the table as 3?" x 4? x ?" Much appreciated. Dave
Bill in OKC too