Keith,
KB states my unit is designed for permanent magnet and shunt wound motors DC motors. This control can use 120 volt AC input and is designed for 90 volt SCR rated motors. I want to use a 24 volt motor.
I am going to contact tech support by phone to get as much direction as I can to determine if the motor I want to use will safely handle the higher voltage of the 90 volt KB unit. If it is determined the 90 volt output could damage my motor I will use a 24 volt power supply as you originally suggested.
If they tell me I can adjust the trim pots to achieve my goal I will try that first.
Does this sound like a reasonable approach?
Dick
--
http://www.homemadetools.net/forum/?OFF-SET-tailstock-center-65965#post105972
?SMALL TURRET TOOL POST PLANS?
?LARGE TURRET TOOL POST PLANS
?MINI-LATHE CARRIAGE LOCK PLANS
?SMALL QC TOOL POST PLANS?
?QUICK CHANGE LATHE TURRET
?MINI LATHE COMPOUND PIVOT MODIFICATION
OldToolmaker