In article <vtP7mGAx3Qc4EwfW@...>, paul
<paul@...> writes
From: paul <paul@...>
Hi All
Very new to ui-view but very impressed so far. I do have a small problem
that someone might have been seen before...
On my own system, using a PK232 or a Tiny-2 the application works well
in KISS mode. My father uses a very old 'BSX board with TNC200 firmware.
It _sort_ of works but the RX data is decoded only when in host mode. If
I enter KISS mode his TX data can be seen at my station but his station
will not RX data from anyone else.
In short it will either TX or RX but not both.
All RF and AF levels are OK.
I get a similar problem with Neil G8UEK who is using a Tiny-2 Mk1 who
cannot use KISS mode..
I can't really answer most of this, because there isn't sufficient
information - Is the BSX an original BSX(1) or a BSX2? What is the
version of the TNC200 firmware? Etc... However, KISS mode works fine
with a Tiny-2 Mk1 (or Mk2) because I've used it. The only likely reason
for it not to work is because KISS is configured incorrectly - for a
Tiny-2 you need to select KISS Setup and click the TNC2 "Easy Setup"
button.
--
Roger Barker, G4IDE roger@...
Boston, UK
