I configured UI-View for "Host Mode NONE", setup the communication
parameters to talk to the right com: port, turned the transceiver and
TNC "on". (I didn't enter a callsign, locatoin or any other parameter
into UI-View...in effect, using it as an RX-only mode).
Immediately, icons appeared (the crowd applauded with approval <g>). It
was then that I attempted to run the terminal window and noticed that
it, too, was RX-only . . . meaning that I couldn't find a way to type in
my own commands that would be heard by the TNC . . . at least not in the
same window as was displaying the received packets. It that my
mistake? Is there another window that becomes "my" window for sending
commands to the TNC? Roger mentions a "single line at the bottom". Am
I simply overlooking it, possibly?
Regards,
Ev, W2EV
--
PropNET: an automated network, designed to
study propagation anomolies. Intreagued?
