开云体育

After a few days rest the problem disappeared.? I love it when that happens.? I was then able to reflash the firmware for good measure. Thanks, Geoffrey. Stephen VE7RSF

Hi, Are you able to get into the Bootloader? I once had a similar issue and solved it by reflashing the

My TT4 powers up with a constant green (power) and yellow (carrier detect) LED's lit.? This is with or without a? radio connected. I am unable to communicate with it via Tera Term.?? It has worked

Robert, That's too bad. I have not talked to Scott for several years now, and I last saw him in Dayton at the Hamvention ( And dinosaurs walked the earth) He had changed his emphasis from radio to

Except they didn't last, and I found Scott's customer service to be awful!I bought the FC-301 (FriendCom), then added the T3-301.? ?? Actually got very good responses when asking how to order the

Thanks Bob, much appreciated! I remember Scott's transceiver, it was very nice!? 73, Allen AF6OF

That's not what's holding me back. Like a lot of hams, I have to watch my radio budget. As is often the case, I need to sell some things before I buy something else. FWIW, Scott Miller at Argent Data

Bob, The four pin header adapter just slides into the holes on the board for programming. It is an interference fit.? If someone had to? the need to program the unit very often, they could install

I'm not understanding how the programming header attaches to the board. The manual says that the programming header adapter is "plugged into the four holes on the MT-AIO". Is this adapter a friction

Bob, et al, The new unit uses an SMA female, just like the previous version. The connector is mounted to the case, rather than soldered to the PCB, so that if the connector is damaged,? it does not

Nice update. I have some questions: 1. Is the antenna removable? What connector does it use? SMA? 2. Is the unit relatively waterproof? I don't expect it to survive being dunked in a lake, but can

We have? inventory in stock for the new Micro-Trak MT-AIO. It is a little smaller, a little more powerful, and a bit lighter than the old MT-AIO, which became a victim of Covid and supplier

Boom. That was the overlooked setting (Alias is set). Got so focused on all the other bells and whistles that I skipped the basic config. thanks much! KE?MIC… Rob

If you want the tt4 to be a digi you have to set ALIAS. KB3KBR Greg. Sent from my Samsung Galaxy smartphone.

Unfortunately still not getting “out”. it is transmitting now. Thanks to previous advice. But not reaching any local digi or gates. My Yaesu FT3D is hitting a nearby spot. So, power, location

Thank you for the suggestions. I should clarify, I had been testing with VOX in various settings; was not getting desired results, then went back to the VOX OFF. I updated settings per your

Well, a few highlighted things below:BPERIOD is 0 ?? ????????? Set this to about 600 for testing, this should generate a TX packet on power up? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ?

Hello all - Rob (KEOMIC), trying to setup a digi using the Baofeng UV-5R and a TinyTrack 4. I've perused the forum; and see the various notes about Baofeng not an optimal choice. However, I am not

"Unsupported packet format" is just aprs.fi reporting that it's parser doesn't understand that specific packet.?? It doesn't affect (AFAIK) other packets from the same station. Why are you using a

Thanks!? Somehow I missed that.? I'm still getting occasional errors but nowhere as many.? I wonder if all the unsupported packets was why I wasn't appearing on aprs.fi maps (even with a 50' high