开云体育

I did not know who that was, so I looked him up.Thanks for the compliment and enlightenment! Robert Giuliano KB8RCO

Rob, William of Ockham would be proud of you today! 73, Allen AF6OF [email protected]> wrote:

Somehow (okay my mistake), this didn't post, but just went to Allen.? Reposting. A couple questions:?? 1.? Are you sure the TT4 has firmware??? ? ?? If not sure, you can use the TT4

Using AMODE TEXT and having set transmit levels, I can type something in the terminal, see it transmitted through the HT and then show up on aprs.fi. Here's an example of what I see on that website.

It is very true that just adding DIGIs can cause harm to the network. These questions are area specific.You should look if there is any local organization for the APRS network near you.? ? Or a

The question was directed at your question.? Your original post says: I'm trying to send and receive from TinyTrak4 in text mode.? It looks like I'm successfully sending messages and I can see them

Good question! I guess I don't know! I wonder what *packets* TinyTrak4 prints when in TEXT mode? Maybe only a limited type? I think I will try and find a TNC program and experiment with that.

You need to be very specific when using the word "message". In APRS context that is a special format for the APRS Message protocol" and the term "message" should not be used to describe the other 95%

Mike, If you are using a handheld radio with your TT4, it probably does not switch back to receive fast enough after a transmission for you to hear its own digipeated traffic. Portables are designed

I am in Southern CA - essentially the corner of the 15 and 60 freeways. Have a TT4, excellent external antenna, and at 5W hitting several other stations. Is there a “mode” I can place my setup in

I made a bit of progress. I drove closer to a digipeater and was able to see some packets. When I send a message, I hear what sounds like an acknowledge message (I must admit, I don't know APRS

Depending upon how you have audio feeding the TT4, you will need to make a few adjustments. The yellow CD light is more or less a carrier detect indicator, and not an indicator that the TT4 is

Assuming you have set the RXAMP properly and your TT4 is decoding packets, the settings you should be looking at are:PKTICOM [ true | false ]??? ????Sets if received packets should be sent to

I'm trying to send and receive from TinyTrak4 in text mode.? It looks like I'm successfully sending messages and I can see them appear on https://aprs.fi/ ( https://aprs.fi/ ) However, I have never

Many thanks Byon and Robert.? I failed to use a 0 in front of the longitude number. Cheers.? Doug KF5BCX

From the firmware manual: LOCATION [ DDMM.mmmmH DDDMM.mmmmH ] Sets the initial default latitude and longitude in degrees and minutes. This value will be used in position reports until overridden by

If you wanted to set your location to 12 deg 34.5678 min north and 123 deg 45.6789 min west, you would enter: LOCATION 1234.5678N 12345.6789W For 12 deg 34.5678 min south and 123 deg 45.6789 min east,

Hi, How do I set LOCATION when my Lat is N and Lon is W ?? The only example I could find is Lat of N and Lon of E.? My location of West Lon is a negative number in Decimal Degrees.? When I follow

That and a way to power the unit. Unfortunately, the TT4 cannot get power from the old DB9 serial cables - at least not without some extra components. You could try JP6 set to Vin, but it didn't work