¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io
  1. TinyTrak
  2. Messages
Single Messages Topics Expanded Polls

Re: Driving GPIO pins

 

You?set up these commands: (they may not be exact since htis is from memory) but similar:

NODISP on
MSGCOMMAND?ON
etc

THen, over the air, you send a message to the devices callsign "!OUT=$FF" where $FF is the state you want for the port bits

Bob


On Sat, Apr 3, 2021 at 1:32 PM Steven Heimann <vk2bos.lists@...> wrote:
Evening all

I have a memory that it is possible to drive a gpio pin in a Tinytrak 4 high or low based on the receipt of an over the air command in an APRS packet.? I have looked at the manuals and this mailing list but can't find anything. I am looking to drive a relay to switch a repeater on and off at a remote mountain site which is battery powered.? Is my memory more faulty than usual?? Could someone point me to some doco on this.

Thanks and regards
Steven VK2BOS

Join [email protected] to automatically receive all group messages.