开云体育

Jorge has a 2465A, so no need to worry about SMD caps failures. Jorge --- one quick question. Did you by any change pull off all the caps and then recap using the service manual as a guide? There is a

Hi Richard,The LVPS?Thanks,GeorgeSent from my T-Mobile 5G Device

Hi George, The issue you show on the YouYube video is power supply capacitor failure. Both my 2465's had this problem. Richard

Merci!!Sent from my T-Mobile 5G Device

More....test 05 fail 24 applies a mains low voltage sine to the trigger hybrid input The fail certainly indicates a mistake in connection probably at CT option board or failed trigger hybrid. See

Bonjour monsieur Have many 2465/7/A/B some with CTT. Recommend 1/ post photos not video of symptoms, boards, etc 2/ post on both tekscopes2 and tekscopes, not the same 3/ get complete service manual

I posted this on the EEVBlog's gigantic thread but have gotten no replies, hopefully I'll get some hits here: Hi all, I'm also a "happy" owner of a 2465A CT. I was having issues with the display

-------- Forwarded Message -------- Subject: 1405 SSB adapter for TV Date: Sat, 17 Aug 2024 21:01:40 -0400 From: Glenn Little WB4UIV <glennmaillist@...> To: [email protected] With the

Morning (UK time) At Tek in the UK, at the old Harpenden site in the late 70's, we used to jet-wash 'scopes (the older 500 series, and some 400 series.? With an industrial detergent/water mix, then

I routinely run boards through the dishwasher, including many boards from these TDS scopes and have yet to kill one. Latest run was an old Asus motherboard (with ISA slots for NI GPIB cards to get a

From the early '89's, I used to buy "ex-rental" colour TVs. If I got a really "smoked up" set, After blowing off any loose stuff, I would remove the chassis and transfer to kitchen sink. Hot water and

Ah, this brings back some memories from when I worked for TEK as a FE in one of the field offices. The service department had a wash rack where they would hose down incoming hardware, and then bake it

Roy, Chuck, Thank you for your thoughts. I am in Southern California, so if anything, we're dry here in just about all seasons. What I did yesterday is towel-absorb all water drops I could see

I knew a guy who would wash dusty/smoky electronic chassis in the sink avoiding transformers and electrolytic capacitors then dry them in an oven on warm for a few hours.? Perhaps drying in an oven

Hi Radu: I've got some scopes left out in the rain (I think on the guy got them from a dumpster.)... Anyway, when I was powering them? on, and checking them out...they appeared dry at the time. I

Mine said "Accept Invite" when i clicked it it said unable to Dean <cheater00social@...> wrote:

It sounds like you first need to log into the account. Then, go to the Discord app - either on mobile, desktop, or in the browser. In the left column where all your Discord servers are listed, scroll

You'd think it's Friday so time to wind down, so as you do that, you stand up pushing the rolling chair against the narrow space at your bench and your large mug with cold water resting right behind

DaveH52 <ac2gl.dave@...> added the photo album Tek 2465 for sale in Montague, NJ ( /g/TekScopes2/album?id=297012 ) : Recapped PS, replaced blower with fan, replaced U800 with

Forgot to mention I'm located in Montague, NJ 07827