开云体育

Question Regarding Vertical Centering - 2465B

n4buq All Messages By This Member #126539 Is there a way to center just the text display independently of the trace centering in the 2465B? The both bottom and top lines of text are displaced several mm upward making the top text a bit hard to see if looking at it from a slightly elevated position. There's a section that describes vertical centering but not sure if that applies to the trace only or both. If there's a way to simply recenter the text without disturbing any calibrations for the trace, etc., I'd like to do that. If not, and the one procedure covers both text and traces, then I'll just follow that one but thought I'd ask first. Thanks, Barry - N4BUQ
Tom Miller Member Profile All Messages By This Member #126541 The readout text is adjusted on the A5 controller board for the 2465B scope. There are two pots, one for the size and one for position. They will not affect the calibration. toggle quoted message Show quoted text ----- Original Message ----- From: Barry n4buq@... [TekScopes] To: TekScopes@... Sent: Monday, April 04, 2016 9:20 AM Subject: [TekScopes] Question Regarding Vertical Centering - 2465B Is there a way to center just the text display independently of the trace centering in the 2465B? The both bottom and top lines of text are displaced several mm upward making the top text a bit hard to see if looking at it from a slightly elevated position. There's a section that describes vertical centering but not sure if that applies to the trace only or both. If there's a way to simply recenter the text without disturbing any calibrations for the trace, etc., I'd like to do that. If not, and the one procedure covers both text and traces, then I'll just follow that one but thought I'd ask first. Thanks, Barry - N4BUQ [Non-text portions of this message have been removed]
n4buq All Messages By This Member #126543 I see it now - under CAL07 (R2918 and/or R2931). Thanks! Barry - N4BUQ toggle quoted message Show quoted text ----- Original Message ----- From: "'Tom Miller' tmiller11147@... [TekScopes]" <TekScopes@...> To: TekScopes@... Sent: Monday, April 4, 2016 10:35:26 AM Subject: Re: [TekScopes] Question Regarding Vertical Centering - 2465B The readout text is adjusted on the A5 controller board for the 2465B scope. There are two pots, one for the size and one for position. They will not affect the calibration. ----- Original Message ----- From: Barry n4buq@... [TekScopes] To: TekScopes@... Sent: Monday, April 04, 2016 9:20 AM Subject: [TekScopes] Question Regarding Vertical Centering - 2465B Is there a way to center just the text display independently of the trace centering in the 2465B? The both bottom and top lines of text are displaced several mm upward making the top text a bit hard to see if looking at it from a slightly elevated position. There's a section that describes vertical centering but not sure if that applies to the trace only or both. If there's a way to simply recenter the text without disturbing any calibrations for the trace, etc., I'd like to do that. If not, and the one procedure covers both text and traces, then I'll just follow that one but thought I'd ask first. Thanks, Barry - N4BUQ

Previous Topic Next Topic