开云体育

Tek 2465B cal 01 problems!! help need!!

iglesia_cristiana_arpas_eternas All Messages By This Member #77686 This is the fifth time, I do CAL 01, and is not good, slow by 4.4% in 5ns, fast by 3.8% in 500ms, second my TG501 5Mhz oven option.. All other time ranges are pretty well. During cal 01 a limit was encountered in step 30,31,32.not enough sweep speed/Horzgain to fill 1 mark division as is prompted . Step 33,34 pass well. I wonder me if a bad timing cap could by the reason?. Any help will be very appreciated. Regards Gabriel.
iglesia_cristiana_arpas_eternas All Messages By This Member #77704 The horizontal U700 shown a CTO in pin 7 cap made in PCB, I suppose for the fastest sweep,could for any reason this cap increase his value..dirt perhaps..? Can I remove the heat-sink of U700 to see this cap?. Since seems that 5ns range is not enough fast, what about to reduce the value in same 4,4% of R723 R724 ?. I have no clue about why the 500mS is wrong!in what step is done his cal? any suggestion?. I will appreciate any inputs. Gabriel. toggle quoted message Show quoted text --- In TekScopes@..., "iglesia_cristiana_arpas_eternas" <iglesia_cristiana_arpas_eternas@...> wrote: This is the fifth time, I do CAL 01, and is not good, slow by 4.4% in 5ns, fast by 3.8% in 500ms, second my TG501 5Mhz oven option.. All other time ranges are pretty well. During cal 01 a limit was encountered in step 30,31,32.not enough sweep speed/Horzgain to fill 1 mark division as is prompted . Step 33,34 pass well. I wonder me if a bad timing cap could by the reason?. Any help will be very appreciated. Regards Gabriel.

Previous Topic Next Topic