开云体育

Any one have a manual for measurements corp. 159 ? Thanks, Mike

Hi everybody, I have a genuine original Tek 1S2 manual (070-0889-00, no serial number). Cover page says Copyright 1966, new material copyright 1968 so it probably covers many instruments. No

the 535a is a fine choice as a general purpose lab scope if 15 mhz will do it. im a bit down on the 545a because of its 4 cm verticle height + very complex vert delay line as a plug in tester i think

timebase.

Christian, BAMA has the 585 manual. A 581 is like a 585 but has only one timebase. The vertical amps will be the same, and the power supplies will be very close. The one sweep on the 581 will be the

Please edit any posts/replies to the list to minimize quoted material to that required for continuity. Please do not send personal replies to the list. List replies go to the original sender by

Hello TekScope Community, apologies for the slightly OT; please admit the following questions: I am looking for informations about Trace Math in the HP 3589A Spectrum / Network Analyzer. The Product

There should be no birdies whatsoever except for the big one at 0 Hz. You have a problem (possibly bad cabling in the front end, although what local signals would be coming through at 41 MHz and 300

Exactly, that is why I'm asking. because for no input my 492 is absolutely clean in the range 0 to 1.8GHz. lc.

i normally look for birdies with no input "shorted with a terminator" when checking a radio receiver or spec ana

Chris, With what signal at the input ? Luis C. ct1dmk.

I've got a 492 that I haven't had for very long and I'm still exploring the possibilities with it. It has options 1,2, and 3. It's a very clean performer and seems to meet its sensitivity specs and is

Good day, A friend of mine has offered me two tube scopes of unknown provenance, he believes however that they are not working. They are Type 581 Serial #001067 Type 535A Serial #025668 BAMA has

I'm need fairly urgent need of a working PS503 and there don't seem to be any around at the usual places. If anybody has one surplus to requirements please let me know. Location Australia. TIA EJP

But the charge on even a pretty large CRT, at least in the olden times, before flatscreens, had pretty impressive HV like 25 kV, and you can get a nasty surprise, but not worse. After all, it's DC,and

There is no surplus stores in the Charleston area that have electronic equipment. There will be a hamfest in the Charleston area Feb 3, 2007. 73 Glenn WB4UIV

Kuba Ober wrote: Also while the "shock" might not kill you, falling backwards or bumping into something from your reflexive action might cause you to break your neck or get impaled on something, or

found this link searching for another document: http://www.bitsavers.org/pdf/ibm/generalInfo/223-6725-2_TekOscopes_Aug60.pdf Guess everybody has known that one since years :) Cheers, Andy

Hi Folks, My instruction manual for my B&K 3050 sine/square generator is missing the schematic. If it's like my other B&K test equipment, the schematic is generally just a folded loose sheet inserted

Kuba Ober wrote: Read again: "but not received payment or shipped, a lovely..."